User manual BOSCH PTK 14 E

[. . . ] 3) Personal safety a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. [. . . ] Use of the power tool for operations different from those intended could result in a hazardous situation. 5) Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The machine is not suitable for the attachment of wall and ceiling panelling. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Trigger Thumbwheel for hammer-force preselection Magazine slider Latching aperture for support foot Latching aperture for spacer clamp Latching aperture for stapler plate Tacker head Duotac automatic selector switch Nail strip* Staple strip* Magazine Support foot* Stapler plate* Spacer clamp* A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. There is danger of injury when unintentionally actuating the On/Off switch. Staples or nails shot from a short distance can cause considerable injuries. Weight according to EPTA-Procedure 01/2003 Protection class PTK 14 E 0 603 265 2. For lower voltage and models for specific countries, these values can vary. The voltage of the power source must agree with the voltage specified on the nameplate of the machine. Switching On and Off At first, firmly place the tacker head 7 against the workpiece until it is pushed in a few millimeters. The trigger lock, which is connected with the movable tacker head 7, prevents unintentional shot actuation when the trigger 1 is inadvertently pressed. Position the machine and press the tacker head 7 firmly against the workpiece until the shot is actuated. After the shot, move the tacker to the next location and press the tacker head 7 firmly onto the workpiece again. hammer-force Preselection With the thumbwheel for hammer-force preselection 2 , it is possible to preselect the required hammer force in steps. The required hammer force depends on the length of the staples or nails, and on the strength of the material. the optimal hammer-force setting is best determined through practical testing. When operating with two staples (Duotac function), the hammer-force preselection must be set approx. We declare under our sole responsibility that this product is in conformity with the following standards or standardization documents: EN 50144 according to the provisions of the directives 89/336/EEC, 98/37/EC. Press on both sides of the magazine slider 3 and pull out the magazine 11. Hold the tacker at a slight angle when inserting the nail strip 9, so that the nails face against the sidewall. [. . . ] If the machine should fail despite the care taken in manufacturing and testing procedures, repair should be carried out by an after-sales service centre for Bosch power tools. In all correspondence and spare parts order, please always include the 10-digit article number given on the type plate of the machine. The wires in the cable are coloured according to the following code: Only for EC countries: Do not dispose of power tools into household waste!According the European Guideline 2002/96/EC for Waste Electrical and Electronic Equipment and its implementation into national right, power tools that are no longer usable must be collected separately and disposed of in an environmentally correct manner. [. . . ]