User manual BOSCH PST 670 REV 12-2008

[. . . ] 3) Personal safety a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. [. . . ] Penetrating a water line causes property damage or may cause an electric shock. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. Products sold in GB only: Your product is fitted with an BS 1363/A approved electric plug with internal fuse (ASTA approved to BS 1362). If the plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place by an authorised customer service agent. the replacement plug should have the same fuse rating as the original plug. The severed plug must be disposed of to avoid a possible shock hazard and should never be inserted into a mains socket elsewhere. Products sold in AUS only: Use a residual current device (RCD) with a rated residual current of 30 mA or less. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The machine is intended for making separating cuts and cut-outs in wood, plastic, metal, ceramic plates and rubber while resting firmly on the workpiece. It is suitable for straight and curved cuts with mitre angles to 45°. A complete overview of accessories can be found in our accessories program. Jigsaw Article number Rated power input Output power Stroke rate at no load n0 Stroke Cutting capacity, max. in wood ­ in aluminium ­ in non-alloy steel Bevel cuts (left/right) , max. Weight according to EPTA-Procedure 01/2003 Protection class W W min For lower voltage and models for specific countries, these values can vary. Typically the A-weighted noise levels of the product are: Sound pressure level 89 dB(A); Sound power level 100 dB(A). The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. [. . . ] Precise cuts are possible only when the guide roller faces tightly against the back of the saw blade. If the machine should fail despite the care taken in manufacturing and testing procedures, repair should be carried out by an after-sales service centre for Bosch power tools. In all correspondence and spare parts order, please always include the 10-digit article number given on the type plate of the machine. Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts. [. . . ]