User manual BOSCH PSR 18 LI-2

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. E) When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. F) If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. [. . . ] The machine is intended for driving in and loosening screws as well as for drilling in wood, metal, ceramic and plastic. 1 Screwdriver bit* 2 Keyless chuck 3 Torque preselection ring 4 Gear selector 5 Indicator for right rotation 6 Indicator for left rotation 7 Soft grip 8 Battery* 9 "Power Light" 10 Battery charge-control indicator 11 Rotational direction switch 12 On/Off switch 13 Battery unlocking button 14 Universal bit holder* 15 Securing screw for keyless chuck 16 Allen key* We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 89/336/EEC, 98/37/EC (until Dec. Cordless Screwdriver Article number Rated voltage No-load speed ­ 1st gear ­ 2nd gear Max. Typically the A-weighted sound pressure level of the product is 70 dB(A). Vibration total values (triax vector sum) determined according to EN 60745: Drilling into metal: Vibration emission value ah =2. The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. The vibration emission level will vary because of the ways in which a power tool can be used and may increase above the level given in this information sheet. This could lead to a significant underestimate of exposure when the tool is used regularly in such a way. Note: To be accurate, an estimation of the level of exposure to vibration experienced during a given period of work should also take into account the times when the tool is switched off and when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Only these battery chargers are matched to the lithium ion battery of your power tool. To ensure full capacity of the battery, charge the battery for at least 3 hours in the battery charger before using for the first time. The lithium ion battery can be charged at any time without reducing its service life. When the battery is empty, the machine is switched off by means of a protective circuit: The inserted tool no longer rotates. Do not continue to press the On/Off switch after the machine has been automatically switched off. ) as well as during transport and storage, set the rotational direction switch to the centre position. This makes quick, convenient and easy changing of the tool in the drill chuck possible. Open the keyless chuck 2 by turning in rotation direction , until the tool can be inserted. The locking is released again to remove the tool when the collar is turned in the opposite direction. ) as well as during transport and storage, set the rotational direction switch to the centre position. [. . . ] The 3 LEDs of the battery charge-control indicator 10 and the Power Light 9 flash rapidly when the battery temperature is not within the operting temperature range of ­10 to +70°C. ) as well as during transport and storage, set the rotational direction switch to the centre position. For safe and proper working, always keep the machine and ventilation slots clean. When the battery is no longer operative, please refer to an authorised after-sales service agent for Bosch power tools. [. . . ]