User manual BOSCH PSR 1200

[. . . ] Remove the battery before any work on the machine itself and before storing it. Before inserting the battery, when changing tools as well as when transporting and storing, always set the rotational direction switch to the centre position! convince yourself before using that the battery is securely seated in the machine. [. . . ] Do not place the battery on radiators or expose to strong sun rays for a longer time; temperatures over 50 °C cause damage. S Do not throw the battery into the household waste, into fire or water. Directly clamp the screwdriver bit into the drill chuck or use the additional universal bit holder 8 when operating with hex shank bits 7. Set the rotational direction switch 3 to the centre position = lock-off and allow the charged battery 5 to engage into the handle. The machine runs with variable speed between 0 and maximum, depending on the pressure applied to the On/Off switch 4. Light pressure results in a low rotational speed thus allowing smooth, controlled starts. Before Putting into Operation Battery Charging A battery that is new or has not been used for a longer period does not develop its full capacity until after approximately 5 charging/discharging cycles. to remove the battery 5 , press the unlocking buttons 6 and pull out the battery downwards. The battery is equipped with an NTC temperature control which allows charging only within a temperature range of between 0 °C and 45 °C. A significantly reduced working period after charging indicates that the batteries are used and must be replaced. For machines without a drill spindle locking facility, the chuck must be changed by an authorised after-sales service shop for Bosch power tools. S It is advisable to first drill a pilot hole before attempting to screw in large, long screws in hard material. Carry out a practical test to determine with which of the 5 settings of the torque setting ring 1 the screws are driven flush into the material. With the correct setting, the clutch disengages as soon as the screw is driven flush into the material or the set torque is reached. [. . . ] Nickel-cadmium-battery: If your product is equipped with a nickel-cadmium-battery, the battery must be collected, recycled or disposed of in an environmentally-friendly way. Defective or worn out batteries must be recycled according to the guidelines 91/157/EEC. Batteries no longer suitable for use can be directly returned at: Great Britain Robert Bosch Ltd. [. . . ]