User manual BOSCH PSM 80 A

[. . . ] 3) Personal safety a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. [. . . ] A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. the declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. The machine is intended for dry sanding and polishing of wood, filler and coated surfaces. It is especially suitable for profiles, corners or hard to reach locations. 1 2 3 4 5 6 7 On/Off switch Dust box, complete (micro filtersystem) Sanding plate Sanding sheet* Extraction outlet Filter element (micro filtersystem) Vacuum hose* Multi Sander Article number Rated power input No-load speed No-load orbital stroke rate Sanding sheet surface Orbit diameter Weight according to EPTA-Procedure 01/2003 Protection class W rpm opm cm2 mm kg PSM 80 A 3 603 C54 0. We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 98/37/EC (until Dec. For lower voltage and models for specific countries, these values can vary. Typically the A-weighted noise levels of the product are: Sound pressure level 83 dB(A); Sound power level 94 dB(A). When attaching a new sanding sheet, remove any dust or debris from the sanding plate 3 (e. To ensure optimum dust extraction, pay attention that the punched holes in the sanding sheet match with the holes in the sanding plate. The sanding plate 3 is fitted with Velcro backing for quick and easy fastening of sanding sheets with Velcro adhesion. Before attaching the sanding sheet 4, free the Velcro backing of the sanding plate 3 from any debris by tapping against it in order to enable optimum adhesion. The machine is fitted with 2 sanding sheets that can be changed individually, depending on the degree of wear. Position the sanding sheet 4 flush alongside one edge of the sanding plate 3, then lay the sanding sheet onto the sanding plate and press it against it with a light turning motion in clockwise direction. [. . . ] For safe and proper working, always keep the machine and ventilation slots clean. If the machine should fail despite the care taken in manufacturing and testing procedures, repair should be carried out by an after-sales service centre for Bosch power tools. In all correspondence and spare parts order, please always include the 10-digit article number given on the type plate of the machine. The voltage of the power source must agree with the voltage specified on the nameplate of the machine. [. . . ]