User manual BOSCH PSB 550 RE

[. . . ] 3) Personal safety a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. [. . . ] Penetrating a water line causes property damage or may cause an electric shock. The tool insert jams when: -- the power tool is subject to overload or -- it becomes wedged in the workpiece. When working with the machine, always hold it firmly with both hands and provide for a secure stance. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. Products sold in GB only: Your product is fitted with an BS 1363/A approved electric plug with internal fuse (ASTA approved to BS 1362). If the plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place by an authorised customer service agent. the replacement plug should have the same fuse rating as the original plug. The severed plug must be disposed of to avoid a possible shock hazard and should never be inserted into a mains socket elsewhere. Products sold in AUS and NZ only: Use a residual current device (RCD) with a rated residual current of 30 mA or less. A complete overview of accessories can be found in our accessories program. Typically the A-weighted noise levels of the product are: Sound pressure level 97 dB(A); Sound power level 108 dB(A). Vibration total values (triax vector sum) determined according to EN 60745: Drilling into metal: Vibration emission value ah =4. 5 m/s2, Impact drilling into concrete: Vibration emission value ah =24 m/s2, Uncertainty K =2 m/s2, Screwdriving without impact: Vibration emission value ah <2. The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. the declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. [. . . ] For driving screws, always position the "Drilling/Impact Drilling" selector switch 4 to the "Drilling" symbol. The voltage of the power source must agree with the voltage specified on the nameplate of the machine. reversing the Rotational Direction (see figures C­D) The rotational direction switch 7 is used to reverse the rotational direction of the machine. 18 | English Right Rotation: For drilling and driving in screws, push the rotational direction switch 7 left to the stop. [. . . ]