User manual BOSCH PSB 18 LI-2 REV 1-2010

[. . . ] 3) Personal safety a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. [. . . ] Combination Cordless Drill Article number Rated voltage No-load speed ­ 1st gear ­ 2nd gear Max. Typically the A-weighted noise levels of the product are: Sound pressure level 89 dB(A); Sound power level 100 dB(A). Vibration total values (triax vector sum) determined according to EN 60745: Drilling into metal: Vibration emission value ah <2. The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. the declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. English | 19 To remove the battery 7, press the battery unlocking button 14 and pull the battery out of the power tool toward the rear. press the On/Off switch 11 to check the charge condition of the battery , see Section "Battery Charge-control Indication". The battery is equipped with a NTC temperature control which allows charging only within a temperature range of between 0 °C and 45 °C. We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 2006/42/EC. The auxiliary handle 12 can be set to any position for a secure and low-fatigue working posture. turn the wing bolt for adjustment of the auxiliary handle 17 in anticlockwise direction and set the auxiliary handle 12 to the required position. Adjusting the Drilling Depth The required drilling depth X can be set with the depth stop 15. Pull out the depth stop until the distance between the tip of the drill bit and the tip of the depth stop correspond with the desired drilling depth X. Only these battery chargers are matched to the lithium ion battery of your power tool. To ensure full capacity of the battery, completely charge the battery in the battery charger before using your power tool for the first time. The lithium ion battery can be charged at any time without reducing its service life. When the battery is empty, the machine is switched off by means of a protective circuit: The inserted tool no longer rotates. [. . . ] Battery packs/batteries: Do not dispose of battery packs/batteries into household waste, fire or water. battery packs/batteries should , if possible , be discharged , collected , recycled or disposed of in an environmental-friendly manner. Only for EC countries: Defective or dead out battery packs/batteries must be recycled according the guideline 2006/66/EC. Batteries no longer suitable for use can be directly returned at: Great Britain Robert Bosch Ltd. [. . . ]