User manual BOSCH PSB 14.4 LI-2@PSB 18 LI-2 REV 2-2009

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. B) Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. unmodified plugs and matching outlets will reduce risk of electric shock. [. . . ] Vibration total values (triax vector sum) determined according to EN 60745: Drilling into metal: Vibration emission value ah <2. The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 98/37/EC (until 28 Dec 2009), 2006/42/EC (from 29 Dec 2009). Eckerhard Strötgen Head of Product Certification For charging, the battery 7 can also remain in the power tool. press the On/Off switch 11 to check the charge condition of the battery , see Section "Battery Charge-control Indication". The battery is equipped with a NTC temperature control which allows charging only within a temperature range of between 0 °C and 45 °C. Only these battery chargers are matched to the lithium ion battery of your power tool. To ensure full capacity of the battery, completely charge the battery in the battery charger before using your power tool for the first time. The lithium ion battery can be charged at any time without reducing its service life. When the battery is empty, the machine is switched off by means of a protective circuit: The inserted tool no longer rotates. Do not continue to press the On/Off switch after the machine has been automatically switched off. The auxiliary handle 16 can be set to any position for a secure and low-fatigue working posture. turn the wing bolt for adjustment of the auxiliary handle 15 in anticlockwise direction and set the auxiliary handle 16 to the required position. Adjusting the Drilling Depth The required drilling depth X can be set with the depth stop 13. Pull out the depth stop until the distance between the tip of the drill bit and the tip of the depth stop correspond with the desired drilling depth X. To remove the battery 7, press the battery unlocking button 12 and pull the battery out of the power tool toward the rear. ) as well as during transport and storage, set the rotational direction switch to the centre position. [. . . ] Before screwing larger, longer screws into hard materials, it is advisable to predrill a pilot hole with the core diameter of the thread to approx. Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts. Exploded views and information on spare parts can also be found under: www. Com Our customer consultants answer your questions concerning best buy, application and adjustment of products and accessories. [. . . ]