User manual BOSCH PKP 7.2 LI REV 7-2010

[. . . ] Under abusive conditions, liquid may be ejected from the battery; avoid contact. penetration of water in the battery charger increases the risk of an electric shock. Only charge Bosch lithium ion batteries or batteries installed in Bosch products with the voltages listed in the technical data. In case of damage and improper use of the battery, vapours may be emitted. [. . . ] Switching On ­ To start the operation, press the On/Off button 7 until the heating indicator 6 lights up green. Meaning The glue is being heated The glue gun is ready for operation Switching Off ­ To switch off, press the On/Off button 7 until the heating indicator 6 goes out. Automatic shut-off: Note: When the glue gun is not used for more than 5 minutes, it automatically shuts off. ­ Switch the glue gun on again and check the battery charge-control indicator 8. When the battery charge-control indicator lights up red continuously, the battery must be recharged. After use, place down the glue gun in a safe manner and allow it to cool down completely before packing it away. Do not allow the hot glue or the nozzle tip to come into contact with persons or animals. If hot glue comes into contact with the skin, hold the affected area immediately under a stream of cold water for several minutes. Use only glues recommended by the manufacturer of the glue gun (see page 112). Preparations for Gluing The surfaces to be glued must be clean, dry and free of grease. English | 19 The materials to be glued as well as the surface on which you are working may not be easily ignitable or inflammable. check the suitability of heat-sensitive materials first on a test workpiece. The ambient temperature and the workpieces to be glued may not be colder than +5 °C and warmer than +50 °C. Materials, such as metal, which cool off the glue quickly, should be preheated with a hot air gun. Gluing ­ Insert the appropriate glue stick 5 for the material being glued via the opening at the rear of the glue gun. ­ Switch the glue gun on and allow it to heat up (see "Switching On", page 17). The glued spot can be subjected to full load after a cool-down period of approx. Textiles) Recommendation Apply the glue in the form of points Apply glue to base material and not to the styrofoam or polystyrene Apply the glue in lines Remove glue residue after cooling with a sharp object. [. . . ] The glue gun, charger, accessories and packaging should be sorted for environmental-friendly recycling. Do not dispose of the glue gun, battery charger and batteries into household waste!Only for EC countries: According to the European Guideline 2002/96/EC, power tools that are no longer usable, and according to the European Guideline 2006/66/EC, defective or used battery packs/batteries, must be collected separately and disposed of in an environmentally correct manner. Batteries no longer suitable for use can be directly returned at: Great Britain Robert Bosch Ltd. [. . . ]