User manual BOSCH PFZ 500 E REV 1-2008

[. . . ] 3) Personal safety a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. [. . . ] Otherwise there is danger of kickback when the cutting tool jams in the workpiece. When the cut is completed, switch off the machine and then pull the saw blade out of the cut only after it has come to a standstill. In this manner you can avoid kickback and can place down the machine securely. Do not brake the saw blade to a stop by applying side pressure after switching off. Use suitable detectors to determine if utility lines are hidden in the work area or call the local utility company for assistance. Penetrating a water line causes property damage or may cause an electric shock. Hold the power tool only by the insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will also make exposed metal parts of the power tool "live" and shock the operator. When working with the machine, always hold it firmly with both hands and provide for a secure stance. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. All purpose saw Article number Rated power input Stroke rate at no load n0 Tool holder Stroke rate control Stroke Cutting capacity, max. Pipe diameter) Weight according to EPTA-Procedure 01/2003 Protection class mm mm mm mm 23 150 10 150 W spm PFZ 500 E 3 603 C98 0. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The machine is intended for sawing wood, plastic, metal and building materials while resting firmly on the workpiece. For lower voltage and models for specific countries, these values can vary. Typically the A-weighted noise levels of the product are: Sound pressure level 88 dB(A); Sound power level 99 dB(A). The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. 1 Saw blade* 2 Guide stop 3 Hand guard 4 On/Off switch 5 Safety switch for On/Off switching 6 SDS saw blade receptacle 7 Slider for SDS saw blade release English | 15 tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. [. . . ] For a quick and clean cut, move the power tool back and forth as with a conventional hand saw. Flush Cuts (see figure D) Using elastic bimetal saw blades, items still attached to a wall (e. Pay attention that the saw blade always extends beyond the diameter of the material being worked. Position the saw blade directly against the wall and apply some lateral pressure via the tool until the footplate faces against the wall. [. . . ]