User manual BOSCH PBH 2000 RE REV 9-2007

[. . . ] D) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. This enables better control of the power tool in unexpected situations. G) If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. [. . . ] Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. The machine is intended for hammer drilling in concrete, brick and stone, as well as for light chiselling work. It is also suitable for drilling without impact in wood, metal, ceramic and plastic. Machines with electronic control and right/left rotation are also suitable for screwdriving. 10 Auxiliary handle 11 Depth stop 12 Key type drill chuck* 13 Extraction sleeve of the dust extraction attachment* 14 Clamping screw for the dust extraction attachment* 15 Depth stop of the dust extraction attachment* 16 Telescopic pipe of the dust extraction attachment* 17 Wing bolt of the dust extraction attachment* 18 Guide pipe of the dust extraction attachment* 19 Universal bit holder with SDS-plus shank* Rotary Hammer Article number Speed control Stop rotation Right/left rotation Delivery Scope ­ Key type drill chuck Rated power input Output power Impact rate Impact energy per stroke Rated speed Tool holder Spindle collar diameter Drilling diameter, max. : ­ Concrete ­ Steel ­ Wood Weight according to EPTA-Procedure 01/2003 Protection class mm mm mm mm kg W W bpm J rpm PBH 2000 RE 3 603 C44 3. For lower voltage and models for specific countries, these values can vary. We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 98/37/EC (until Dec. , drills with cylindrical shank), a suitable drill chuck must be mounted (key type drill chuck or keyless chuck, accessories). Inserting the Key Type Drill Chuck (see figure C) Clean the shank end of the adapter shank and apply a light coat of grease. Insert the key type drill chuck with the adapter shank into the tool holder with a turning motion until it automatically locks. Removing the Key Type Drill Chuck Push the locking sleeve 3 toward the rear and pull out the key type drill chuck 12. Rotating the Auxiliary Handle (see figure A) The auxiliary handle 10 can be set to any position for a secure and low-fatigue working posture. turn the wing bolt for adjustment of the auxiliary handle 9 in anticlockwise direction and set the auxiliary handle 10 to the required position. Adjusting the Drilling Depth (see figure B) The required drilling depth X can be set with the depth stop 11. Otherwise, the movability of the SDS-plus drilling tool can lead to incorrect adjustment of the drilling depth. Pull out the depth stop until the distance between the tip of the drill bit and the tip of the depth stop correspond with the desired drilling depth X. The dust protection cap 2 largely prevents the entry of drilling dust into the tool holder during operation. When inserting the tool, take care that the dust protection cap 2 is not damaged. Inserting SDS-plus Drilling Tools (see figure D) The SDS-plus drill chuck allows for simple and convenient changing of drilling tools without the use of additional tools. Insert the tool in a twisting manner into the tool holder until it latches itself. This causes a certain radial run-out at no-load, which has no effect on the accuracy of the drill hole, as the drill bit centres itself upon drilling. [. . . ] Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts. Exploded views and information on spare parts can also be found under: www. Com Our customer consultants answer your questions concerning best buy, application and adjustment of products and accessories. Only for EC countries: Do not dispose of power tools into household waste! [. . . ]