User manual BOSCH PAS 12-27 F REV 9-2009

[. . . ] Do not operate the machine in rooms where the danger of an explosion exists. water entering the vacuum cleaner increases the risk of an electric shock. When operating the vacuum cleaner in damp environments, use a residual current device (RCD). Using a residual current device (RCD) reduces the risk of an electric shock. [. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The machine is intended for vacuuming and extraction of materials that are not hazardous to one's health and for non-flammable liquids. Use the vacuum cleaner only when you fully understand and can perform all functions without limitation, or have received appropriate instructions. Typically the A-weighted sound pressure level of the product is 77 dB(A). We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60335 according to the provisions of the directives 2006/95/EC, 2004/108/EC. 1 Cable holder 2 Carrying handle 3 Socket for power tool (PAS 12-27 F) 4 Latch of the vacuum cover 5 Container 6 Vacuum hose 7 Release button for hose connection piece 8 Hose connection piece 9 On/Off switch (PAS 11-21/PAS 12-27) 9 Mode selector switch (PAS 12-27 F) 10 Vacuum lid 11 Permanent filter 12 Float 13 Accessory holder Container volume (gross) Dust bag contents Vacuum* Airflow* Dust category (BIA) Weight according to EPTA-Procedure 01/2003 Protection class For lower voltage and models for specific countries, these values can vary. Please observe the article number on the type plate of your vacuum cleaner. note: For vacuuming , the permanent filter 11 always must be inserted. Make sure that the full length of the dust bag 14 faces against the inner wall of the container 5. When using a dust bag 14, the permanent filter 11 remains unclogged longer, the vacuuming performance is maintained longer, and the disposal of dust is made easier. ­ Pull off the full dust bag 14 from the connection flange toward the rear. Insert the vacuum hose 6 into the hose connection piece 8 until it is locked. English | 15 Insert the accessory holder 13 from above onto the holder of the vacuum lid 10. Afterwards, insert the angle piece into the accessory holder 13 from the bottom until it can be heard to latch. For disassembly of the accessory holder 13, press the ends of the angle piece together and pull it out towards the bottom. Operation with remote automatic switching (see figure B) (PAS 12-27 F) A socket outlet with earthing contact 3 is integrated in the vacuum cleaner, which allows for connection of an external power tool. The vacuum cleaner is automatically put into operation via the power tool. For connecting power tools, various hose systems are available as accessories. To remove the vacuum hose 6, press the unlocking button 7 to the left and pull out the vacuum hose 6 at the same time. The voltage of the power source must agree with the voltage specified on the nameplate of the vacuum cleaner. [. . . ] Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts. Exploded views and information on spare parts can also be found under: www. Com Our customer service representatives can answer your questions concerning possible applications and adjustment of products and accessories. Only for EC countries: Do not dispose of vacuum cleaners into household waste! [. . . ]