User manual BOSCH NGU4151DB

[. . . ] Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. D) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. [. . . ] In accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. 5) Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. Penetration of water into the machine increases the risk of an electric shock. , when sparks emit from sanding metals, sanding debris in the dust bag, micro filter or paper sack (or in the filter sack or filter of the vacuum cleaner) can self-ignite. Particularly when mixed with remainders of varnish, polyurethane or other chemical materials and when the sanding debris is hot after long periods of working. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. Products sold in GB only: Your product is fitted with an BS 1363/A approved electric plug with internal fuse (ASTA approved to BS 1362). If the plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place by an authorised customer service agent. the replacement plug should have the same fuse rating as the original plug. Guide the other end of the sanding sheet 6 under the front sanding-sheet clamp 4 and clamp the sanding sheet by reinserting the sanding-sheet clamp 4. We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 2006/42/EC. From rolls or by the meter, can be punctured with the perforating tool 11 for use with dust extraction. For this, press the machine with the mounted sanding sheet onto the perforating tool (see figure E). to remove the sanding sheet 6 , unlatch the sanding-sheet clamp 4 and pull out the sanding sheet. Selecting the Sanding Sheet Depending on the material to be worked and the required rate of material removal, different sanding sheets are available: Grain size 40--240 For the working of all wooden materials For coarse-sanding, e. Of rough, unplaned beams and boards For face sanding and planing small irregularities For finish and fine sanding of hard woods Dusts from materials such as lead-containing coatings, some wood types, minerals and metal can be harmful to one's health. Touching or breathing-in the dusts can cause allergic reactions and/or lead to respiratory infections of the user or bystanders. Certain dusts, such as oak or beech dust, are considered as carcinogenic, especially in connection with wood-treatment additives (chromate, wood preservative). Integrated Dust Extraction with Dust Box (see figures C1­C4) Attach the dust box 3 onto the extraction outlet 8 until it latches. Before opening the dust box 3, it is recommended to loosen the dust from the filter element by gently striking it against a firm support (as shown in the figure). [. . . ] If the machine should fail despite the care taken in manufacturing and testing procedures, repair should be carried out by an after-sales service centre for Bosch power tools. In all correspondence and spare parts order, please always include the 10-digit article number given on the type plate of the machine. Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts. Exploded views and information on spare parts can also be found under: www. [. . . ]