User manual BOSCH HGV74W355A

[. . . ] . 1 28 Installation instructions en B-080789-01 9000 459462 Table of contents General information . 19 Adjusting or replacing the burner bypass nozzles (small flame setting) . 27 3 General information Converting your appliance so that it can use a different type of gas must be carried out by an authorised expert or by the after sales service in accordance with these installation instructions. We assume no liability for damage and malfunctions caused by connection and setting errors. 4 Important information For details regarding the connection of your appliance, see the rating plate on the rear of the appliance. [. . . ] We recommend that the isolation valve be fitted prior to the cooker to enable isolation of cooker from gas supply. To find out the factory set gas type, see rear of cooker next to gas connection. Use pipe compound or thread sealant, properly threaded pipes and careful assembly procedure so that there is no cross threading, etc. , which might cause damage or leakage. Make sure that all connections performed are free of leakage. 11 WARNING TO THE INSTALLER INSTALLATION WITH A HOSE ASSEMBLY Only install with a hose assembly that complies with AS/NZS 1869 (AGA Approved), 10mm ID, class B or D, no more than 1. 2 m long and in accordance with AS5601. Ensure that the hose does not contact the hot surfaces of the hotplate or an oven, dishwasher or other appliance that may be installed next to the cooker. WARNING: Ensure that the hose assembly is restrained from accidental contact with the flue or flue outlet of an underbench oven. The hose should not be subjected to abrasion, kinking or permanent deformation and should be able to be inspected along its entire length. Unions compatible with the hose fittings must be used and connections tested for gas leaks. Before Leaving Check all connections for gas leaks with soap and water. Ignite all burners both individually and separately to ensure correct operation of gas valves, burners and ignition. Turn gas taps to low flame position and observe stability of the flame for each burner individually and all together. Only in this way can a correct installation be guaranteed. Caution d Gas connection: Never connect the appliance outlet directly to the gas pipe. Always use the connecting pieces that are supplied with the appliance. Type of connection Country ISO 7 1 AU NZ Australia New Zealand x x 14 Connection for natural gas (NG) Connection in accordance with ISO 7 1 With natural gas (NG), the gas connection is made via a gas tube or a flexible security tube equipped with a screw thread at both ends. 1. Attach the connecting piece (SW24) to the gas connection (SW22). 3. Secure the screw thread (SW24) of the gas tube or flexible security gas tube to the connecting piece with a suitable sealant. The gas pressure regulator supplied with the appliance must be installed in line with the gas pipe (NG only). 5. Note d Observe the country specific requirements. 15 Connection for liquefied gas (LPG) With liquefied gas (LPG), the gas connection must be made via a flexible gas tube or a fixed tube. Important information for the use of a flexible gas tube: A flexible security gas tube or a plastic tube with a diameter of 8 or 10 mm must be used. It must be secured to the gas connection with a permissible connection device (e. g. Observe current requirements. Note It must be replaced once a year. d Observe the country specific requirements. Screw in the connecting piece (SW24) to the gas connection (SW22). 3. Insert the flexible security gas tube and tighten securely with the screw thread or suitable hose clamp. [. . . ] 18. Tighten the front panel using the two corresponding screws (T15) (M4). 19. Reinsert the screws (T20) that were removed from the right and left front profiles and tighten them. Make sure that the plastic parts that must remain under the screws do not fall. 21. For models with a wok cooking zone (option): reinsert the 4 (T20) screws (M4) that you unscrewed from the gas cooking zone. [. . . ]