User manual BOSCH GST 85PE

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. B) Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. unmodified plugs and matching outlets will reduce risk of electric shock. [. . . ] This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. The machine is intended for making separating cuts and cut-outs in wood, plastic, metal, ceramic plates and rubber while resting firmly on the workpiece. It is suitable for straight and curved cuts with mitre angles to 45°. 1 Rotatable top handle with pushbutton 2 Thumbwheel for stroke rate preselection (GST 85 PE) 3 Allen key 4 On/Off switch 5 Switch for sawdust blowing device 6 Adjusting lever for orbital action 7 Base plate 8 Guide roller 9 Saw blade* 10 Contact protector 11 Stroke rod 12 Splinter guard* 13 Scale for mitre angle 14 Screw 15 Angle gauge** Jigsaw Article number Stroke rate control Rated power input Output power Stroke rate at no load n0 Stroke Cutting capacity, max. in wood ­ in aluminium ­ in non-alloy steel Bevel cuts (left/right) , max. Weight according to EPTA-Procedure 01/2003 Protection class W W spm mm mm mm mm ° kg GST 85 P Professional 0 601 584 1. For lower voltage and models for specific countries, these values can vary. We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 98/37/EC (until Dec. Selecting a Saw Blade An overview of recommended saw blades can be found at the end of these instructions. The saw blade should not be longer than required for the intended cut. Before inserting the saw blade 9, set the adjusting lever for orbital action 6 to setting III. ­ Press the orange pushbutton in the rotatable top handle 1 down until it can be felt to engage. ­ Insert the saw blade 9 lateral to the cutting direction into the stroke rod 11. ­ Turn the saw blade 9 so that the toothing faces toward the cutting direction. ­ Turn the rotating handle 1 in the direction of the arrow until a click can be heard. ­ Push up the orange pushbutton at the rotatable top handle 1 again to the starting position. Orbital Action Settings The four orbital action settings allow for optimal adaptation of cutting speed, cutting capacity and cutting pattern to the material being sawed. [. . . ] For this, press the orange pushbutton beyond the latching point and pull off the rotatable top handle upward at the same time. Before assembling the rotatable top handle 1, push up the orange pushbutton back into the starting position again. Attach the rotatable top handle 1 and press downward until it can be felt to engage. Coolant/Lubricant When sawing metal, coolant/lubricant should be applied alongside cutting line because of the material heating up. [. . . ]