User manual BOSCH DWW091451A

[. . . ] The complete installation set and replacement filters can be obtained from specialist outlets. The corresponding accessory numbers can be found at the end of these operating instructions. The extractor-hood fan extracts the kitchen vapours which are purified in the grease filter and activated carbon filter and then conveyed back into the kitchen. The grease filter absorbs the grease particles in the kitchen vapours. [. . . ] Replacing the activated carbon filters: During normal operation (1 to 2 hours per day) the activated carbon filters should be replaced approximately 1 x year. The activated carbon filters are available from specialist outlets (see Optional accessories). Disposal of old activated carbon filters: Activated carbon filters do NOT contain any harmful substances. They can therefore be disposed of as household refuse. Activated carbon filter: For neutralizing odours in recirculating mode. Caution: As the filter becomes more and more saturated with grease, there is an increased risk of fire and the function of the extractor hood may be impaired. Important: Change the activated carbon filter promptly to prevent the risk of fire from the accumulation of heat when deep-fat frying or roasting. 7 Cleaning and care Isolate the extractor hood by pulling out the mains plug or switching off the fuse. Do not clean the extractor hood with abrasive sponges or with cleaning agents which contain sand, soda, acid or chlorine! Clean the extractor hood with a hot soap solution or a mild window cleaner. When cleaning the grease filters, remove grease deposits from accessible parts of the housing. This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency. Clean the switch with a soft, damp cloth (mild detergent solution) only. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. Clean the surface in the same direction as it has been ground and polished. Observe the warranty regulations in the enclosed service booklet. Replacing the light bulbs 1. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Replace the bulb (standard filament bulb, max 40 W, E14 bulb holder). 5. Plug the appliance into the mains or switch it on at the fuse box. 8 Installation Instructions: Important information Old appliances are not worthless rubbish. Please contribute to a better environment by disposing of packaging materials in an environmentally-friendly manner. Please ask your dealer or inquire at your local authority about current means of disposal. The extractor hood can be used in exhaust air or circulating air mode. Minimum distance between electric hob and bottom edge of extractor hood: 550 mm, Fig. The extractor hood must not be installed over a solid fuel cooker ­ a potential fire hazard (e. g. [. . . ] In order to help fix the hood onto the wall, screw in the middle screw (without a washer) until it protrudes by approx. Before the 4 screws are tightened down, align the extractor hood properly. Screw the upper flue duct to the sides of the fixing bracket with 2 short screws. 13. Position the lower flue duct on the extractor hood and screw the extractor hood to the flue duct from below with 2 long screws. [. . . ]