User manual BOSCH DLE-50 PROFESSIONAL

[. . . ] There is an increased risk of electric shock if your body is earthed or grounded. Never use the cord for carrying, pulling or unplugging the power tool. E) When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. [. . . ] In case of damage and improper use of the battery, vapours may be emitted. When the battery is defective, liquid can escape and come into contact with adjacent components. penetration of water in the battery charger increases the risk of an electric shock. The battery charger is suitable only for charging Bosch lithium ion batteries within the listed voltage range. English | 39 Before each use, check the battery charger, cable and plug. Have repairs performed only by a qualified technician and only using original spare parts. damaged battery chargers , cables and plugs increase the risk of an electric shock. The heating of the battery charger during the charging process can pose a fire hazard. Products sold in GB only: Your product is fitted with an BS 1363/A approved electric plug with internal fuse (ASTA approved to BS 1362). If the plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place by an authorised customer service agent. the replacement plug should have the same fuse rating as the original plug. Do not continue to press the On/Off switch after the machine has been automatically switched off. The charging procedure starts as soon as the main plug of the battery charger is inserted into the socket and the cordless screwdriver is afterwards placed on the battery charger 10. The battery is fully charged when the indicator lights up green continuously. Disconnect the battery charger from the mains supply when not using it for longer periods. English | 45 The power tool cannot be used during the charge procedure; it is not defective when inoperative during the charging procedure. ) as well as during transport and storage, set the rotational direction switch to the centre position. This makes quick, convenient and easy changing of the tool in the drill chuck possible. Open the keyless chuck 2 by turning in rotation direction , until the tool can be inserted. The locking is released again to remove the tool when the collar is turned in the opposite direction. ) as well as during transport and storage, set the rotational direction switch to the centre position. The keyless chuck 2 is secured with a securing screw 12 against unintentional loosening from the drill spindle. [. . . ] When the battery is empty, the machine is switched off by means of a protective circuit: The inserted tool no longer rotates. Tips After longer periods of working at low speed, allow the machine to cool down by running it for approx. Before screwing larger, longer screws into hard materials, it is advisable to predrill a pilot hole with the core diameter of the thread to approx. ) as well as during transport and storage, set the rotational direction switch to the centre position. [. . . ]