User manual BOSCH DHE635BGB

[. . . ] / DHE 645. . . en Operating and Installation instructions Internet: http://www. bosch-hausgeraete. de Bosch Info-Team: de Tel. 650 2 Instructions for Use Appliance description Operating modes If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded. Note: When assessing the overall requirement, the combined ventilation system for the entire household must be taken into consideration. [. . . ] Push the filter screen up slightly, lift it towards you over the brackets and take it out downwards. Insert activated carbon filter in the lower left corner of the housing. Shift it until both hooks slot into the holes and then secure in place with the wing nut. 2. 3. Insert the screw through the wing nut and bushing and screw into the housing (only necessary upon initial fitting. Push in the lower edge over the brackets and lower the screen into place. 1. 1. 2. Check that the filter screen is securely located behind the retaining brackets on both sides. Using a screwdriver or similar, press the two lugs in the housing through to the back (only necessary upon initial fitting). Replacing the activated carbon filter: During normal operation (daily 1 to 2 hours) the activated carbon filter must be replaced approximately 1x year. The activated carbon filter can be purchased FROM YOUR DEALER (see Optional accessories). Only use original filters. These ensure optimum function. Disposal of the old activated carbon filter: Activated carbon filters do not contain any harmful substances. 8 Cleaning and care Isolate the extractor hood by pulling out the mains plug or switching off the fuse. When cleaning the grease filters, remove grease deposits from accessible parts of the housing. This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency. Clean the extractor hood with a hot soap solution or a mild window cleaner. Note: Do not use alcohol (spirit) on plastic surfaces, as dull marks may appear. Changing the bulbs 1. Switch off the extractor hood and deenergize by pulling out the mains plug or switching off the fuse. Press the edges of the lamp cover together where indicated and lift it out towards you. Caution: Ensure that the kitchen is adequately ventilated. Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Do not use stainless-steel cleaner to clean the operating buttons. 3. Reinsert mains plug or switch on the fuse. Faults If you should have any questions or there are any faults, call customer service (see list of customer service units). (FD) Aluminium and plastic surfaces: Use a soft, non-linting window cloth or micro-fibre cloth. Do not use abrasive agents. Enter these numbers in the spaces above. You will find the numbers on the rating plate inside the extractor hood after removing the filter screen. 9 Installation instructions Important information Old appliances are not worthless rubbish. [. . . ] Connect the blue (Neutral) wire to the terminal in the plug marked `N' or coloured black. Installation Please note: A wall hanging set can be obtained from your dealer (see section on special accessories) for fastening the hood (e. g. Connect the brown (Live) wire to the terminal marked `L', or coloured red. The extractor hood may be connected to a correctly installed earthed socket only. Attach the earthed socket near the extractor hood in an accessible position. If appliances do not feature the OFF delay function, the indicator may start flashing when the extractor hood has been switched off for several hours via a separate switch, even though the grease filters are not yet saturated. [. . . ]