User manual BOSCH AKE 35-19 S

[. . . ] Remove the plug from the socket or mains immediately before carrying out any adjustments, servicing or maintenance or if the cable is damaged or cut. Obtain and wear eye and ear protection at all times while operating the power tool. S Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. S Children and juveniles, except above age 16, under supervision and for educational purposes, must not operate the chain saw, nor should persons unfamiliar with the saw or its handling (when borrowing). [. . . ] Do not operate chain saw after drinking alcohol or under the influence of intoxicating drugs or medication. Electrical Safety Your machine is double insulated for safety and requires no earth connection. Extension cords/leads should only be used if they comply with H07 RN-F types or IEC type design (60 245 IEC 66). If you want to use an extension cable when operating your product, only the following cable dimensions should be used: ­ 1. 5 mm2: max length 100 m It is recommended for increased electrical safety to use a Residual Current Device (RCD) with a tripping current of not more than 30 mA. For products not sold in GB: WARNING: For safety, it is essential that the mains plug 23 attached to the machine is fitted to the power supply cable 25 as shown. The couplings of connection leads must be protected against splashes and the coupling sockets on the leads must be made of rubber or coated with rubber. The connection lead must be inspected for signs of damage at regular intervals and may only be used if in perfect condition. if the supply cord is damaged , it must be replaced by a Bosch Service Centre. Products sold in GB only: Your chain saw is fitted with an approved 13 A (BS 1363/A) electric plug and is protected by a 13 A fuse (ASTA Approved to BS 1362). If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place by an authorized customer service agent. Ensure power cord is located to the rear, away from the chain and wood and so postioned that it will not be caught on branches or the like during cutting. F The chain must be running at full speed before it makes contact with the wood. Use the metal gripping teeth 11 to secure the saw onto the wood before starting to cut. Use the gripping teeth as a leverage point "X" while cutting. Reset the gripping teeth at a lower point when sawing thicker logs by pulling the chain saw slightly backwards until the gripping teeth release, and reposition at lower level to continue sawing. Do not force the chain while cutting, let the chain do the work, using the gripping teeth 11 to apply minimal leverage pressure. G Do not operate the chain saw with arms fully extended or attempt to saw areas which are difficult to reach, or on a ladder. Sawing is optimized when the chain speed remains steady during cutting. The weight of the saw may change unexpectedly as it cuts free from the wood. Cutting Logs Observe the following safety instructions: E H Support logs so that the face sides at the cut do not close in against each other, which would result in the chain being jammed or pinched. , as these could be thrown up or cause damage to the chain or serious injury to the operator or bystanders. [. . . ] If the chain saw should happen to fail despite the care taken in manufacturing and testing, repair should be carried out by an authorized customer service agent. For all correspondence and spare parts orders, always include the 10-digit part number (TYP) from the nameplate of the machine!The circular groove of the chain bar will wear particularly on the lower edge with time. When replacing the chain turn the chain bar 180° to allow even wear, thus extending chain bar life. [. . . ]