User manual BLACK & DECKER KR705K

[. . . ] Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. [. . . ] ) • • • • • • • • Vibration The declared vibration emission values stated in the technical data and the declaration of conformity have been measured in accordance with a standard test method provided by EN 60745 and may be used for comparing one tool with another. The declared vibration emission value may also be used in a preliminary assessment of exposure. The vibration emission value during actual use of the power tool can differ from the declared value depending on the ways in which the tool is used. When assessing vibration exposure to determine safety measures required by 2002/44/EC to protect persons regularly using power tools in employment, an estimation of vibration exposure should consider, the actual conditions of use and the way the tool is used, including taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time. €¢ • Safety of others • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. €¢ Residual risks Additional residual risks may arise when using the tool which may not be included in the enclosed safety warnings. Labels on tool The following pictograms are shown on the tool: 5 ENGLISH Warning!To reduce the risk of injury, the user must read the instruction manual. A) • Slacken the side handle (8) by turning the grip counterclockwise. The maximum drilling depth is equal to the distance between the tip of the drill bit and the front end of the depth stop. Electrical safety This tool is double insulated; therefore no earth wire is required. Always check that the power supply corresponds to the voltage on the rating plate. €¢ If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. • • Fitting an accessory (fig. B & C) Keyless chuck with spindle lock (Where supplied) (fig. B) • Open the chuck by turning the sleeve (9) counterclockwise. C) • Open the chuck by turning the sleeve (11) counterclockwise. Insert the chuck key (12) into each hole (13) in the side of the chuck and turn clockwise until tight. Before assembly, make sure that the tool is switched off and unplugged. Remove the chuck retaining screw, located in the chuck, by turning it clockwise using a screwdriver. Tighten an Allen key into the chuck and strike it with a hammer as shown. [. . . ] The product has sustained damage through foreign objects, substances or accidents. Repairs have been attempted by persons other than authorised repair agents or Black & Decker service staff. KR705, KR805, KR806, KR1001 Black & Decker declares that these products described under "technical data" are in compliance with: 2006/42/EC, EN 60745-1, EN 60745-2-1 For more information, please contact Black & Decker at the following address or refer to the back of the manual. The undersigned is responsible for compilation of the technical file and makes this declaration on behalf of Black & Decker. [. . . ]