User manual BIONAIRE BU3000

[. . . ] Never turn on, plug in or unplug the humidifier while your hands are wet in order to avoid electric shock. If the humidifier is not level always turn the power off before handling it. Do not disassemble the humidifier while it is plugged in to avoid electric shocks. If you need to replace the plug or cable always refer to the instructions. [. . . ] IMPORTANT: If you do not plan to use your humidifier for two or more days, make sure any residual water is drained from the tank and base to prevent any bacteria growth in stagnant water. cARE AND CLEANING Humidifiers provide comfort by adding moisture to dry , heated indoor air. To get the most benefit from the humidifier and to avoid product misuse, follow all instructions carefully, specifically the operation, care and maintenance guidelines. Please note this is an electrical appliance and requires attention when in use. Cleaning your humidifier every one or two weeks, depending on the water conditions is important in order to maintain efficient, healthy, odour-free operation. Water quality varies widely and, combined with build-up of mineral scale in your humidifier, may under certain conditions promote the growth of micro-organisms in the water tank. before cleaning , Please note the following: · DO NOT use soap, detergents, abrasives, gasoline, glass or furniture polish, or boiling water to clean any part of your Ultrasonic Humidifier. These will interfere with the proper operation of your unit and may affect its appearance. DO NOT use sharp or metal objects to clean mineral deposits in the reservoir. Mineral deposits should be soaked for up to 20 minutes in plain vinegar and water to help with their removal. Before cleaning, set the humidity control switch to the Off position ( ) and unplug the unit from the electrical outlet. Carry the base and the tank to the sink, then drain and rinse the base and tank thoroughly to remove any sediment or dirt. Be sure the humidifier is disconnected from the wall outlet and humidity control switch (C) is in the off position ( ). Then, take the tank (E) off the unit to refill it (without moving the base). If the humidifier is not level always turn the power off before handling it. Power on light indicator (B) will illuminate when the unit is connected to main electrical power and operating. When the unit is out of water or when the unit is switched off, the Power on light indicator will not be working. Turn your humidifier on by rotating the humidity control switch (C) to the high position ( ) It will take a few minutes before full moist air output is obtained. Please note the mist may not be visible straight away at the low setting. IMPORTANT: When the unit runs out of water, the transducer will automatically shut off. Turn the humidity control switch anti-clockwise to the off ( ) position, then unplug the unit. Before refilling the tank, empty any residual water and follow the Daily maintenance instructions. [. . . ] Pack the humidifier in its original carton and store in a cool, dry place. And Ireland only: If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. And Ireland The wires in the mains lead are coloured as such: BROWN LIVE BLUE NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings 4 Please proceed as follows: The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK. [. . . ]