User manual BIONAIRE BU1500

[. . . ] Never turn on, plug in or unplug the humidifier while your hands are wet in order to avoid electric shock. If the humidifier is not level always turn the power off before handling it. Do not disassemble the humidifier while it is plugged in to avoid electric shocks. If you need to replace the plug or cable always refer to the instructions. [. . . ] before cleaning , Please note the following: · DO NOT use soap, detergents, abrasives, gasoline, glass or furniture polish, or boiling water to clean any part of your Ultrasonic Humidifier. These will interfere with the proper operation of your unit and may affect its appearance. DO NOT use sharp or metal objects to clean mineral deposits in the reservoir. Mineral deposits should be soaked for up to 20 minutes in plain vinegar and water to help with their removal. Disconnect the elephant humidifier from the transformer before cleaning. Before cleaning, set the humidity control switch to the Off position ( ) and unplug the unit from the electrical outlet. Humidifier is not plugged in or Plug into power socket and turn the humidity control switch is on the humidity control switch clockwise. Pour some of the water from the water tank inlet and replace the tank. Increase the humidity level by turning the Humidity Control Knob from Min ( ) to Max ( ). The humidity control has scale, the water is dirty or has not been changed for some time. Be sure the humidifier is disconnected from the wall outlet and humidity control switch (C) is in the off position ( ). Then, take the tank (E) off the unit to refill it (without moving the base). If the humidifier is not level always turn the power off before handling it. Power on light indicator (B) will illuminate when the unit is connected to main electrical power and operating. When the unit is out of water or when the unit is switched off, the Power on light indicator will not be working. Turn your humidifier on by rotating the humidity control switch (C) to the high position ( ) It will take a few minutes before full moist air output is obtained. Please note the mist may not be visible straight away at the low setting. IMPORTANT: When the unit runs out of water, the transducer will automatically shut off. Turn the humidity control switch anti-clockwise to the off ( ) position, then unplug the unit. Carry the base and the tank to the sink, then drain and rinse the base and tank thoroughly to remove any sediment or dirt. STORAGE TIPS If you do not plan to use your unit for an extended period of time, (i. During the summer months), it is important that you follow these instructions to help prevent stagnation of water in the unit. [. . . ] Then, take the tank (E) off the unit to refill it (without moving the base). Power on light indicator (B) will illuminate when the unit is connected to main electrical power and operating. When the unit is out of water or when the unit is switched off, the Power on light indicator will not be working. Please note the mist may not be visible straight away at the low setting. [. . . ]