User manual BIONAIRE BT150R

[. . . ] · If stored assembled or partially assembled, remember to protect the fan head from dust. · Be sure to use a soft cloth, moistened with a mild soap solution. · Do not use any of the following as a cleaner: petrol, thinners or benzene. NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. If a 13A 3-pin plug is fitted, it must be an ASTA approved plug, conforming to BS1363 standard. [. . . ] If your appliance includes a country-specific guarantee or warranty insert please refer to the terms and conditions of such guarantee or warranty in place of this guarantee or contact your local authorized dealer for more information. Waste electrical products should not be disposed of with Household waste. E-mail us at enquiriesEurope@jardencs. com for further recycling and WEEE information. Holmes Products (Europe) Limited 1 Francis Grove London SW19 4DT UK pure indoor living Holmes Products (Europe) Ltd. 1 Francis Grove London SW19 4DT England Fax: +44 (0)20 8947 8272 Email: enquiriesEurope@jardencs. com UK - Filter Sales Order Line - 0870 759 9000 Website address: www. bionaire. com UK - Free phone Customer Service Helpline ­ 0800 052 3615 Slim Tower Fan MODEL# BT150R SPR-091009 © 2009 Sunbeam Products, Inc. Distribué par Holmes Products (Europe) Ltd. , 1 Francis Grove, London SW19 4DT, United Kingdom. Distributed by Holmes Products (Europe) Ltd. , 1 Francis Grove, London SW19 4DT, United Kingdom. 6 D F C H E B G PLEASE READ AND SAVE THESE INSTRUCTIONS IMPORTANT INSTRUCTIONS When using electrical appliances, basic safety precautions should always be taken including the following:· Use the fan only for purposes described in the instruction manual. · To protect against electrical shock, do not immerse the fan, plug or cord in water or spray with liquids. · Close supervision is necessary when any appliance is used by or near children. · Unplug from the electrical outlet when not in use, when moving the fan from one location to another, before putting on or taking off parts and before cleaning. · Do not operate in the presence of explosive and/or flammable fumes. · Do not operate fan until fully assembled with all parts properly in place. · To avoid fire hazard, NEVER place the cord under rugs or any parts near an open flame, cooking or other heating appliance. · Ensure that the fan is switched off from the supply mains before removing the guard. · Do not operate any appliance with a damaged cord, plug, after the appliance malfunctions, or has been dropped/damaged in any manner. · The use of attachments not recommended or sold by the appliance manufacturer may cause hazards. · Do not let the cord hang over the edge of a table or counter, or come into contact with hot surfaces. [. . . ] No light = no timer and unit stays on until you turn unit off with the ASSEMBLY INSTRUCTIONS (See Fig. Assemble Base Halves with cord running through the middle slot, by sliding them together, aligning the 4 male parts with the 4 female parts as seen in Fig. Secure assembled base to the fan housing (F) with 4 securing screws (G) as seen in Fig. [. . . ]