User manual BIONAIRE BOH2503D

[. . . ] · The BROWN coloured wire must be connected to the pin terminal, which is marked with the letter L (Live) or is coloured RED. · The BLUE coloured wire must be connected to the pin terminal which is marked with the letter N (Neutral) or is coloured BLACK. · DO NOT CONNECT either of these wires to the earth terminal in the plug. The earth terminal is marked with the letter E ( ) or is coloured GREEN, or GREEN & YELLOW. [. . . ] Distribué par Holmes Products (Europe) Ltd. , 1 Francis Grove, London SW19 4DT, United Kingdom. Imprimé en RPC SPR-051010 P/N: 138197 INSTRUCTION MANUAL BOH2503D Fig. 2 PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS When using electrical appliances, basic safety precautions should always be taken including the following: 1. Before connecting the heater, check that the voltage indicated on the rating plate corresponds to the main voltage in your home/office. WARNING: In order to avoid overheating, do not cover the heater ( ) Reference to product. DO NOT use this heater in the immediate surroundings of a bath, a shower or a swimming pool. If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or similarly qualified person in order to avoid hazard. Should the product suffer damage or breakdown, it must be returned to the manufacturer or their service agent. Under the environment with electrical fast transient, the product may malfunction. DO NOT use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. DO NOT position where it can be touched by children, especially the very young. Allow a safe area around the heater away from furniture or other objects; at least 50 cm from the top and sides and 200 cm at the front. Keep the mains cord at a safe distance from the main body of the heater. If overheating should occur, the built-in overheating safety device will switch off the heater. The heater cannot be used adjacent to curtains or combustible material. Curtains or combustible material may be burned if the heater was installed incorrectly. 19. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have 2 been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Repairs requiring opening of the oil container are only to be made by the manufacturer or his service agent who should be contacted if there is an oil leak; 21. When scrapping the heater, follow the regulations concerning the disposal of oil. U-bolt Technical Specifications BOH2503D: Wattage: 2500W ASSEMBLY INSTRUCTIONS (See Fig. 3) Please make sure the heater has not been plugged into any electricity outlet. [. . . ] To deactivate the thermostat setting, press the thermostat/timer button continuously until the thermostat symbol does not appear on the display. NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. FROST GUARD INSTRUCTION When the heater is in frost guard mode, the temperature will be maintained at 5° C; thus the heater will be in the off status unless the room temperature is lower than 5° C. If the room temperature is lower than 5° C, the heater will automatically start working and will keep turning on & off all the time, maintaining its ambient temperature of 5° C. [. . . ]