User manual BIONAIRE BOH2503-I

[. . . ] Keep the mains cord at a safe distance from the main body of the heater. If overheating should occur, the built-in overheating safety device will switch off the heater. The heater cannot be used adjacent to curtains or combustible material. Curtains or combustible material may be burned if the heater was installed incorrectly. [. . . ] To activate, press the mode button to turn the unit on, then press the thermostat/timer button twice. NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. Please make sure you have all of the following accessories prior to throwing away packaging. 2 Castor assemblies with four castors (R, G, & Q), and 2 U Bolts with wing nuts (T, P, S). 3) Please make sure the heater has not been plugged into any electricity outlet. After using the heater, press the mode button until the unit is deactivated and the mode light turns off, then turn the power switch to the OFF position. After setting the time, the digital display will stop flashing to show the timer is activated. The timer will count down until the predetermined length of time has passed, and the heater will then automatically switch off. The heater is running and you require the heater to switch off at 10 pm; therefore, set the time to 9 hours. Press the thermostat/timer button (M) once to activate thermostat setting. Press the + or - adjuster buttons (N) to select the desired temperature. If the heater is on, press the thermostat/timer control button 4 times. Using either the (+) or (-) adjuster buttons, 5 Setting the ON timer BOH2503D-I_IB_REV. After setting the ON timer, the digital display will stop flashing to show the timer is activated. The timer will count down until the predetermined period has passed, and then the heater will automatically switch on. NOTE: When the ON timer is set, the unit will remember the setting the unit was previously on and activate to this setting after the predetermined period. The heat setting may be changed after setting the timer by pressing the mode button. Programme the heater to switch on up to 24 hours later, in increments of 1 hour. Example - 4 hours TIP OVER PROTECTION When the unit is accidentally knocked over, or tilts on one side at more than a 45° angle; it will instantly shut off. To reset, simply place the heater in an upright position and press the mode button to reactivate the unit. ENERGY SAVING MODE To activate, press the mode button until appears on the display. the heater will operate on a cycle - 10 minutes on High (2500W) and 30 minutes on Medium (1300W). [. . . ] For at aktivere, tryk på funktionsknappen, for at tænde for enheden, tryk derefter på termostat/timer knappen to gange. For at nulstille, placeres varmeapparatet i opretstående position og tryk på funktionsknappen for at genaktivere enheden. Timeren vil tælle ned indtil den forudindstillede tidsperiode er Eksempel - 4 timer LAGRINGSTIPS Dersom man ikke trenger å bruke ovnen over en lengre periode, for eksempel om sommeren, bør den oppbevares ved romtemperatur, på et tørt sted, og helst tildekket for å unngå at det samler seg støv og smuss på den. For å hindre skade på miljø eller helse fra ukontrollert avfallshåndtering på grunn av farlige stoffer i produktet, må det resirkuleres ansvarlig for å muliggjøre bærekraftig gjenbruk av materialer og ressurser. [. . . ]