User manual BIONAIRE BOH2001W

[. . . ] DO NOT use this heater in the immediate surroundings of a bath, a shower or a swimming pool. If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or similarly qualified person in order to avoid hazard. Should the product suffer damage or breakdown, it must be returned to the manufacturer or their service agent. Under the environment with electrical fast transient, the product may malfunction. [. . . ] Place the front stand (G) on the bottom of the radiators front panel, and secure it with the Q shape screw (K). This front stand (G) is not meant to be removed once it is attached to the bottom of the unit. After installation of the front stand (G) and foot plate (M) with casters (L) turn the heater the right way up: the heater is now ready for use. Heater will be in the off status unless the room temperature is lower than 5° C. If the room temperature is lower than 5° C, the heater will automatically start working and will keep turning on & off all the time, maintaining its ambient temperature of 5° C. TIP OVER PROTECTION When the unit is accidentally knocked over, or tilts on one side at more than a 45° angle; it will instantly shut off. NOTE: Unit must be unplugged for it to be fully off The Power Light (I) will illuminate and remain lit until the heater is unplugged. NOTE: When the heater is in use, it is normal that the heater cycles ON and OFF, this is to maintain your desired temperature. After using the heater, turn the Control Knob (H) to "0" position, turn the Thermostat Knob (J) to lowest temperature position and unplug the heater from the socket. If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. For correct type and correct installation please refer to "Installation of a plug" below. STORAGE TIPS If the heater is not required for long periods, for example during the summer, it should be stored at room temperature; in a dry place and preferably covered to prevent the accumulation of dust and dirt. When the desired temperature/comfort level is reached, turn the thermostat control anti-clockwise to lower position or until the heater stops operating. The control will now automatically maintain the pre-set temperature level by turning the heater ON and OFF. ANTI-FROST GUARD INSTRUCTION If you plug in the heater, it will start working at the lowest temperature setting (When thermostat control is in the lowest temperature position, the temperature will be maintained at 5° C, thus the 3 The wires in this mains lead are coloured as such: Earth Live Neutral NOTE: If you are in any doubt about wiring and the installation of the plug. Turn the heater upside down and you will see one U-bolt (O) with wing nut over the last joint of the heater. Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. GUARANTEE Please keep your receipt as this will be required for any claims under this guarantee. [. . . ] The BLUE coloured wire must be connected to the pin terminal which is marked with the letter N (Neutral) or is coloured BLACK. DO NOT CONNECT either of these wires to the earth terminal in the plug. The earth terminal is marked with the letter E ( ) or is coloured GREEN, or GREEN&YELLOW. Waste electrical products should not be disposed of with Household waste. [. . . ]