User manual BIONAIRE BH1551

[. . . ] JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory warranty or condition. Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. JCS disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise. JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. [. . . ] NEVER locate heater where it may fall into a bathtub or other water container. Extreme caution is necessary when any heater is used by, or near children or invalids, and whenever the heater is left operating and unattended. DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater. DO NOT operate heater with a damaged cord or plug, or after the heater malfunctions, has been dropped or damaged in any manner. Return appliance to manufacturer for examination, electrical or mechanical adjustment, or repair. DO NOT use it in areas where gasoline, paint, or flammable liquids are used or stored. Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by the manufacturer may cause hazards. To prevent a possible fire, DO NOT block air intakes or exhaust in any manner. DO NOT use on soft surfaces, like a bed, where openings may become blocked. To disconnect heater, turn controls to OFF, then remove plug from outlet. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. If the heater will not operate, see specific instructions on Auto Safety Shut-off. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. It is recommended that the outlet be replaced if plug or outlet is hot to touch. F E AT U R E S - O P E R AT I O N S TECHNICAL SPECIFICATIONS 1. Make sure the unit is in the OFF position before ·Workingvoltage:120VAC/60Hz plugging the heater into the outlet. Avoid overloading your circuit by not using other high Feet Assembly wattage appliances in the same outlet. There are two feet packed within the box that you will need to attach to the heater (Please refer to Fig. Using force, attach one of the feet to the bottom · heremaybeanodorcomingfromtheheaterthefirst T housing of the heater (as shown in Fig. This is normal during the break-in will snap into place and is not meant to be taken apart period. Make sure the heater is in a well ventilated area after attached to the heater. [. . . ] To reset, simply place the heater in an upright position and turn ON the heater. B C PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS A. Power light D If your heater fails to operate: · hetemperaturemaybesettoolow. Turnthe T thermostat knob clockwise until the heater restarts. ·UNPLUGTHEUNITandmakesuretheheaterisplaced in an upright position. · Checkforobstructions. Ifyoufindanobstructionturn the heater OFF, and unplug the unit. [. . . ]