User manual BIONAIRE BFH912

[. . . ] If overheating should occur, the built-in overheating safety device will switch off the heater. The heater cannot be used adjacent to curtains or combustible material. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. [. . . ] NOTE: To shut the heater off at any time press the Power Button ( ) until the LCD display goes off. The heater will cool down for 15 seconds, and the Fan Only indicator light will blink in Amber until cool down is completed. The digital thermostat has memory, it will remember the last temperature setting before the heater is turned off. However, if the heater is unplugged, the digital thermostat will not longer remember the previous temperature setting. Timer Your model is equipped with a 24 Hour Auto shut-off timer feature. This allows you to programme your heater to shut off automatically after running a defined time interval (from 0-24 hours). Turn the Dial Wheel (+/-) to adjust from 0-24 to select your desired time interval for the heater to shut-off automatically. The selected hour will appear on the LCD display, and then the timer indicator light will stop blinking in 3 seconds to indicate that the selected timer is activated. AUTO SAFETY SHUT OFF This heater is equipped with a technologicallyadvanced safety system that requires the user to reset the heater if there is a potential overheat situation. When a potential overheat temperature is reached, the system will automatically shut the heater off. If the heater shuts off and the Power Light is flashing, please follow the specific reset instructions below: 1. NOTE: If the heater is plugged in again and Power On/Off Button is pressed within the 30-minute cool down period, heater will run at High Heat (2) setting, but shut down in 2 seconds with the Power Light flashing. Please repeat the above 3 steps to reset the heater again and ensure to allow sufficient time for the thermostat to cool down. Allow sufficient time to dry before plugging the unit back in the socket. Clean the air inlet and outlet openings regularly (with normal use at least twice a year) with a vacuum cleaner. AND IRELAND ONLY If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. If this plug is unsuitable or needs to be replaced, please note the following: The wires in the mains lead are coloured as such: BROWN LIVE BLUE NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. Please proceed as follows: The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK. DO NOT CONNECT either of these wires to the earth terminal in the plug. The earth terminal plug is marked with the letter "E", or with the earth symbol , or coloured GREEN, or GREEN and YELLOW. [. . . ] The thermostat automatically turns the heater on and off to maintain selected comfort level. When the heater is in thermostat mode and reaches the set temperature it will autmocatically perofrm a 15 second cool down (blowing cold air) to ensure thermostat accuracy. To make this occur less frequently turn the Dial Wheel (+) to the highest setting. Probable Cause You may hear a popping or crackling sound as the heater heats up. [. . . ]