User manual BIONAIRE BFH910

[. . . ] If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or similarly qualified person in order to avoid hazard. Should the product suffer damage or breakdown, it must be returned to the manufacturer or their service agent. Under the environment with electrical fast transient, the product may malfunction and require user to reset the product. Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. [. . . ] As noted above, you need to turn the Thermostat Control (G) to the full clockwise position to start the heater. When the desired temperature/ comfort level is reached, lower the thermostat setting until the heater stops operating. This is done by moving the the Thermostat control(G) anticlockwise toward the Frost Guard setting ( ). The thermostat is set to 5°C at the Frost Guard setting ( ), the heater will turn on automatically if the temperature goes below 5°C so as to avoid a frost situation. The control will now automatically maintain the pre-set temperature level by turning the heater ON and OFF. nOTE: It is normal for the heater to cycle ON and OFF as it it maintains the preset temperature. To prevent the unit from cycling , you need to change the thermostat setting. AUTO SAFETY SHUT OFF This heater is equipped with a technologicallyadvanced safety system that requires the user to reset the heater if there is a potential overheat situation. When a potential overheat temperature is reached, the system will automatically shut the heater off. If the heater shuts off, please follow the specific reset instructions below: 1. Allow sufficient time to dry before plugging the unit back in the socket. Clean the air inlet and outlet openings regularly (with normal use at least twice a year) with a vacuum cleaner. Troubleshooting for your Heater Solution Follow reset instructions listed in this manual. Position your heater at least 50cm away from obejcts for the top, back and sides and at least 200cm distance away from objects for the front grill. The thermostat automatically turns the heater on and off to maintain selected comfort level. There may be an odor or vapor coming from the heater the first time you use it or after prolonged or seasonal storage. To make this occur less frequently adjust the Thermostat Control clockwise to the highest setting. If the noise persists please call local Bionaire service reprensentative. This is normal and is the result of dust or other debris accumulating on the heating element. Make sure the heater is in a well ventilated area and continue running until the odor or vapor goes away. [. . . ] The rights under this guarantee shall only apply to the original purchaser and shall not extend to commercial or communal use. If your appliance includes a country-specific guarantee or warranty insert please refer to the terms and conditions of such guarantee or warranty in place of this guarantee or contact your local authorized dealer for more information. Waste electrical products should not be disposed of with Household waste. NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. [. . . ]