User manual BIONAIRE BFH6500

[. . . ] Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by the manufacturer may cause hazards. To prevent a possible fire, DO NOT block air intakes or exhaust in any manner. [. . . ] If the unit will not start in the digital thermostat mode, please make sure the "preset temperature" is higher than the current room temperature. nOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting. When the preset temperature is reached, the fan will run for 30 seconds without heat. This cool down process ensures an accurate and consistent temperature reading. If you unplug the heater, you will have to reset the digital thermostat again by following the above instructions. The digital thermostat will remember the previous temperature setting after the unit has been turned off. However, if the unit is unplugged, the digital thermostat will be reset and will no longer remember the previous temperature setting. USING THE PROGRAMMABLE TIMER Digital thermostat allows the user to program the heater to turn on at a preset time, or turn off after a set amount of time. While the heater is running, press and hold the up and down buttons simultaneously. By pressing the up and down buttons, program the heater to turn off in up to 16 hours from the current time, in increments of 1 hour. After setting the timer, the LED display will return to show the current room temperature. After the predetermined length of time has passed, the heater will automatically shut off. While the heater is off, press and hold the up and down buttons simultaneously. By pressing the up and down buttons, program the heater to turn on up to 16 hours in advance of current time, in increments of 1 hour. After the preset length of time has passed, the heater will automatically turn on at the last mode setting that was programmed. Please do not manually turn the heater on the base; it is designed to turn only by motorized oscillation. Instruction Leaflet ¤ INFO-LINE If after having read this leaflet, you have any Questions or comments on your heater, call 1-800-253-2764 in North America. Before operation, insert 2 "AAA" batteries into the back of the remote control. MODES: To scroll through the various modes LO, HI, AL and AH press the Mode/On Button until you reach your desired setting. From there you can press the Temp Up or Temp Down button , which will give you the ability to program the heater to turn on or off in 1 hour increments, up to 16 hours. For your convenience a remote control holder is integrated into the heater. [. . . ] Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. jCS disclaims all other warranties , conditions or representations , express , implied , statutory or otherwise. JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you. [. . . ]