User manual BIONAIRE BFH251

[. . . ] NOTE: The Thermostat (C) must be turned to the maximum setting to being operating the fan setting. You need to set Thermostat (C) on the maximum temperature and the Mode Control (B) to a heat setting to start the heater. When the desired temperature / comfort level is reached, lower the thermostat setting until the fan/heater stops operating. The control will now automatically maintain the pre-set temperature level by turning the heater ON and OFF. [. . . ] If the heater is tipped over, unplug it and allow it to cool before standing it back up. ) CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility. This appliance is not intended for use by persons (including children) with reduced Physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. bATHROOM USE UK ONLY: · Regulations prevent the use of this heater in the bathroom. iN OTHER COUNTRIES · If this heater is going to be used in a bathroom, or similar room, it must be installed: a. In such a way that the switches and other controls cannot be touched by the person in the bath or shower. If you are unsure about the installation of this heater in the bathroom we recommend that you seek advice from a professional electrician/installer. Safety in use · Extra caution is necessary when the heater is used near children or when it is left unattended. Keep the mains cord at a safe distance from the main body of the heater. If overheating should occur, the built-in overheating safety device will switch off the heater. DO NOT use aerosols, inflammable substances or materials sensitive to heat in the flow of hot air. Should the heater stop working, first check the fuse in the plug (UK only) or fuse / circuit breaker at the distribution board is operating, before contacting the manufacturer or service agent. If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid hazard. The heater contains no user serviceable parts and should the product suffer damage or breakdown it must be returned to the manufacturer or their service agent. Allow sufficient time to dry before plugging the unit back in the socket. Clean the air inlet and outlet openings regularly (with normal use at least twice a year) with a vacuum cleaner. And Ireland only: If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. [. . . ] Faults that occur through, improper use, damage, abuse, use with incorrect voltage, acts of nature, events beyond the control of Holmes, repair or alteration by a person other than a person authorised by Holmes or failure to follow instructions for use are not covered by this guarantee. Additionally, normal wear and tear, including, but not limited to, minor discoloration and scratches are not covered by this guarantee. The rights under this guarantee shall only apply to the original purchaser and shall not extend to commercial or communal use. If your appliance includes a country-specific guarantee or warranty insert please refer to the terms and conditions of such guarantee or warranty in place of this guarantee or contact your local authorized dealer for more information. [. . . ]