User manual BIONAIRE BCM7203

[. . . ] NEVER place it on a rug or carpet, or on a finished floor that may be damaged by exposure to water or moisture. Shut off and unplug before removing the NEVER use detergents, gasoline, glass cleaner, furniture polish, paint thinner, or other household solvents to clean any part of the humidifier. Excessive humidity in a room can cause water condensation on windows and some furniture. Do not use humidifier in an area where humidity level is in excess of 50%. [. . . ] NOTE: When the SmartTouchTM Electronic Humidistat is set, either the HIGH or LOW power light and the percent humidity light will remain lit during operation. do not mix alkaline , standard (carbon-zine) , or rechargeable (nickel-cadmium) batteries. REPLACING THE FILTERS: Through normal use, waterborne minerals and sediment become trapped in the wick filters. The harder your water, the greater the amount of minerals in the water, and the more often you will need to change your filters. You will be able to monitor the life of the filters in your humidifier by checking the FilterCheckTM Indicator. The FilterCheckTM Indicator will only read the filter condition when the humidifier is in operation. Figure 3 NOTE: It may take up to 60 minutes of operation for the FilterCheckTM Indicator to reflect the filter condition. After frequent use of your humidifier, the FilterCheckTM Indicator will let you know when the filters need to be changed, see Figure 3. When the needle is in the (CHANGE) section, this means the proper amount of moisture is not getting into your air due to the excessive minerals and sediment that have Become trapped on your filters. Push the SmartTouchTM button (MODE/OFF) for 2 seconds to turn the unit OFF and disconnect from the electrical outlet. Do not remove rivet, replacement wicks come equipped with rivets for easy replacement. Insert new filters into each section of the wick holder making sure the rivet attaches to the wick holder securely. Do not use wicks without rivets as they will not produce the unit's intended output. Replace the wick holder into the base (it can only go in by following the arrow indicator) and replace main housing and then tank. It will take about 30 minutes for the humidifier to reach maximum output. You can purchase replacement filters (Model BWF100) by calling 1-800-253-2764 or by visiting www. To benefit most from the humidifier and avoid product misuse, follow all instructions carefully. Please note that this is an electrical appliance and requires attention when in use. In addition, if you do not follow the recommended care and maintenance guidelines, micro-organisms may be able to grow in the water within the water tank. You must routinely follow the cleaning procedures that follow in order to ensure proper, efficient operation of your humidifier. Proper maintenance and cleaning is essential to the continued performance of your unit and the avoidance of algae or bacteria build-up. Instruction Leaflet INFO-LINE If after having read this leaflet, you have any Questions or comments on your humidifier, call 1-800-253-2764 in North America. [. . . ] Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. jCS disclaims all other warranties , conditions or representations , express , implied , statutory or otherwise. JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you. [. . . ]