User manual BIONAIRE BCM6100

[. . . ] NEVER place it on a rug or carpet, or on a finished floor that may be damaged by exposure to water or moisture. Shut off and unplug before removing the water reservoir and moving the unit. NEVER use detergents, gasoline, glass cleaner, furniture polish, paint thinner, or other household solvents to clean any part of the humidifier. Excessive humidity in a room can cause water condensation on windows and some furniture. [. . . ] The unit will cycle on and off to maintain the "Set" humidity at high setting. In this mode the unit will run to maintain the "Set" humidity. Press Mode button on remote again for "Med" and "Auto", and again for "Low" and "Auto". The unit will cycle on and off to maintain the "Set" humidity at the designated setting. To turn unit "Off", press the Mode button and the LCD will go blank (except for Filter Monitor Fig 3 the "Room" humidity display which is always displayed while batteries are Low in the remote) and the unit Med will shut off. EXTENDED RUN TIME SETTING: By setting you humidifier to a specific humidity level, you are actually also extending the run time. Since the unit will turn on and off to maintain the set humidity level, less water will be used, so you will need to fill the unit less than you would on manual setting. UNIT OPERATION WITHOUT REMOTE Your humidifier can be operated directly from the control panel located on the top of the unit A. The "High" light illuminates and the unit runs in "High" mode. Note: The "auto" light only illuminates when the unit is set to "auto" mode by the remote. The unit will then switch "Modes"; either from "High" to "Med", "Med" to "Low", or "Low" to "Off". The Remote will display a different mode ­ the mode in which it was left. If a button is pressed on the Remote, the Remote's signal will override the "Mode" on the unit and the two will be back in sync. 3) Push + or - to adjust the number of hours the unit will run before it automatically shuts itself off. 2) 1 through 8 will scroll in a continuous loop 4) After you have made your selection, the whole screen flashes for 5 seconds after last button push of + or then goes back to previous mode 4. CONSUMER SAFETY INFORMATION THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC (a plug having one blade wider than the other). If it still does not fit, contact qualified personnel to install the proper outlet. 5) At any time if you unlock the remote and push the mode button to turn the unit off, the timer setting will be erased and "timer" will disappear from the remote. 6) To check how much time is remaining , press and hold the + and ­ buttons simultaneously. Using Timer to Turn Unit On This function is meant for a person to pre-humidify a room by setting the timer. For Example: It's 8 am, and you want to come home to a humidified room at 8 pm. To accomplish this place the unit in the desired room and set the timer to turn the unit on in 12 hours. [. . . ] Fill the tank all the way full, place it on the base, let the water empty into the base until it stops bubbling, then refill the tank full again. In areas with hard water your wick filter will need to be changed frequently. Replace your wick filter (WF6000) by calling 1-800-253-2764, or visit www. WARRANTY The Manufacturer warrants to the original retail purchaser, for TWO (2) YEARS from the date of original purchase, either to repair or replace at its option, without charge (parts and labor), any supplied or manufactured part of this humidifier which, upon inspection by an authorized service center, proves to have failed in normal use due to defects in material or workmanship, or, at its option, to replace the unit. [. . . ]