User manual BIONAIRE BCH4821

[. . . ] Please recycle where facilities exist. Check on the following website for further recycling and WEEE information: www. bionaire. com/europe or e-mail info-europe@theholmesgroup. com Holmes Products (Europe) Ltd 1 Francis Grove London SW19 4DT England ® CERAMIC Heater with ViziHeatTM BCH4821 ® Fax: +44 (0)20 8947 8272 Email: info-europe@theholmesgroup. com Website address: www. bionaire. com/europe UK - Free phone Customer Service Helpline ­ 0800 052 3615 © 2006 JCS/THG, LLC Bionaire® , the Bionaire logoTM and ViziHeatTM are trademarks of JCS/THG, LLC. 9100020007251 BCH4821IUK06EM2 INSTRUCTION MANUAL BCH4821IUK06EM2 V. qxd 7/5/06 11:15 Page 4 BCH4821 Fig. Oscillation Button G. Front Panel B OPERATING INSTRUCTIONS Setting the Mode 1. For heater operation, turn the Mode Control (A) to the desired setting: I - Low setting (1000 Watts) II - High setting (2000 Watts) 2. For fan-only operation, without any heat output, turn the Mode Control (A) to the FAN ( ) setting. [. . . ] NOTE: If left in extreme cold temperatures (- 22° F/-30°C) the ViziHeatTM color changing display may not perform. NOTE: The ViziHeatTM colour changing effect may wear off after continuous, heavy use of the heater or in time. FROST-GUARD SETTING This special setting will automatically turn on the heater if the room's temperature reaches freezing. To set, turn the Thermostat Control all the way to minimum temperature level, and turn the Mode Control to either HI (II) or LO (I). AUTO SAFETY SHUT-OFF This heater is equipped with a technologically advanced, safety system that requires the user to reset the heater if there is a potential overheat situation. When a potential overheat temperature is reached, the system will automatically shut the heater off. Tip-Over Protection When the unit is accidentally knocked over, it will instantly shut off. Safety Back-Up Fuse In the unlikely case the heater does not respond to an overheat situation, the safety back-up fuse will engage. Please contact your local service number on the back of the manual for advice. PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS When using electrical appliances, basic safety precautions should always be taken including the following: 1. Before connecting the heater, check that the voltage indicated on the rating plate corresponds to the main voltage in your home/office. WARNING: In order to avoid overheating, do not cover the heater . A A D B E G C 3. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool. If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or similarly qualified person in order to avoid hazard. Should the product suffer damage or breakdown, it must be returned to the manufacturer or their service agent. Under the environment with electrical fast transient, the product may malfunction and require user to reset the product. Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. DO NOT position where it can be touched by children, especially the very young. [. . . ] If a 13A 3-pin plug is fitted, it must be an ASTA approved plug, conforming to BS1363 standard. GUARANTEE PLEASE KEEP YOUR RECEIPT AS THIS WILL BE REQUIRED FOR ANY CLAIMS UNDER THIS GUARANTEE · Your heater is guaranteed for 2 years. · In the unlikely event of breakdown, please take your heater back to the place of purchase, with your till receipt and a copy of this guarantee. · The rights and benefits under this guarantee are additional to your statutory rights which are not affected by this guarantee. [. . . ]