User manual BIONAIRE BCH160B-I

[. . . ] If overheating should occur, the built-in overheating safety device will switch off the heater. The heater cannot be used adjacent to curtains or combustible material. Curtains or combustible material may be burned if the heater was installed incorrectly. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Turn Mode Control to OFF (O) position and the Thermostat Control to the fully anticlockwise position. Unplug unit from socket and wait 30 minutes for the unit to cool down. Allow sufficient time to dry before plugging the unit back in the socket. € Clean the air inlet and outlet openings regularly (with normal use at least twice a year) with a vacuum cleaner. Make sure the unit is in the OFF (O) position before plugging the heater into the wall socket/outlet. Once plugged in, the power light ring (D) will remain lit during operation. Avoid overloading your circuit by not using other high wattage appliances in the same outlet. Mode Control Turn the Mode Control (E) to the desired setting: O - Off Mode If you want to shut off the heater at any time of operation, turn the mode button to OFF (O) position. The power light ring will remain lit until the heater is turned to OFF (O). - Fan only Setting The heater will run at Fan-only operation without any heat output. Position your heater at least 50cm away from obejcts for the top, back and sides and at least 200cm distance away from objects for the front grill. Unexpected Noise ☛ The thermostat automatically turns the heater on and off to maintain selected comfort level. ˜ There may be an odor or vapor coming from the heater the first time you use it or after prolonged or seasonal storage. œ To make this occur less frequently adjust the Thermostat Control clockwise to the highest setting. œ If the noise persists please call local Bionaire service reprensentative. œ This is normal and is the result of dust or other debris accumulating on the heating element. Make sure the heater is in a well ventilated area and continue running until the odor or vapor goes away. AND IRELAND ONLY If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. Please proceed as follows: The BROWN coloured wire must be connected to the terminal, which is marked with the letter “L” or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter “N” or is coloured BLACK. [. . . ] To prevent possible harm to the environment or human health from uncontrolled waste disposal due to the presence of hazardous substances within the product, recycle it responsibly to promote the sustainable reuse of materials and resources. To return your used device, please use the return and collection systems available to you or contact the retailer where the product was purchased. FÖRSIKTIGHET: För att undvika fara på grund av att värmesäkringen oavsiktligt återställs, får denna apparat inte anslutas genom en extern kopplingsanordning, till exempel en klocka, eller till en krets där strömmen regelbundet stängs av och sätts på. Lägesväljare Vrid lägesväljaren (E) till önskad inställning: O - Läget Av Om du vill stänga av värmeelementet under drift, vrid lägesknappen till läget AV (O). [. . . ]