User manual BIONAIRE BCH160

[. . . ] Holmes undertakes within the guarantee period to repair or replace the appliance, or any part of appliance found to be not working properly free of charge provided that: · you promptly notify the place of purchase or Holmes of the problem; and · the appliance has not been altered in any way or subjected to damage, misuse, abuse, repair or alteration by a person other than a person authorised by Holmes. Faults that occur through, improper use, damage, abuse, use with incorrect voltage, acts of nature, events beyond the control of Holmes, repair or alteration by a person other than a person authorised by Holmes or failure to follow instructions for use are not covered by this guarantee. Additionally, normal wear and tear, including, but not limited to, minor discoloration and scratches are not covered by this guarantee. The rights under this guarantee shall only apply to the original purchaser and shall not extend to commercial or communal use. [. . . ] Under the environment with electrical fast transient, the product may malfunction and require user to reset the product. Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. DO NOT position where it can be touched by children, especially the very young. B C BCH160 Fig. 2 11. Allow a safe area around the heater away from furniture or other objects; at least 50 cm from the top and sides and 200 cm at the front. Keep the mains cord at a safe distance from the main body of the heater. If overheating should occur, the built-in overheating safety device will switch off the heater. The heater cannot be used adjacent to curtains or combustible material. Curtains or combustible material may be burned if the heater was installed incorrectly. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility. OPERATING INSTRUCTIONS 1. Make sure the unit is in the OFF (O) position before plugging the heater into the wall socket/outlet. Once plugged in, the power light ring (D) will remain lit during operation. Avoid overloading your circuit by not using other high wattage appliances in the same outlet. Mode Control Turn the Mode Control (E) to the desired setting: O - Off Mode If you want to shut off the heater at any time of operation, turn the mode button to OFF (O) position. The power light ring will remain lit until the heater is turned to OFF (O). - Fan only Setting The heater will run at Fan-only operation without any heat output. NOTE: To start the heater operation, make sure the Thermostat Control (F) is turned to the full clockwise position. Before setting the thermostat, allow heater to operate and warm up the room. As noted above, you need to turn the Thermostat Control (F) to the full clockwise position to start the heater. [. . . ] · Clean the air inlet and outlet openings regularly (with normal use at least twice a year) with a vacuum cleaner. FOR U. K. AND IRELAND ONLY If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. and Ireland only F E NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. If a 13A 3-pin plug is fitted, it must be an ASTA approved plug, conforming to BS1363 standard. [. . . ]