User manual BIONAIRE BASF40LM

[. . . ] ⷠUnplug from the electrical outlet when not in use, when moving the fan from one location to another, before putting on or taking off parts and before cleaning. Do not place the fan or any parts near an open flame, cooking or other heating appliance. ⷠDo not operate any appliance with a damaged mains cable, plug, after the appliance malfunctions, or has been dropped/damaged in any manner. [. . . ] This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance Using a cross head screw driver, remove the screws (U) from the neck joint (T) of the motor housing assembly. Align the screw holes of the neck joint (T) with the screw holes of the upper extension pole (H) and secure with the two screws (U) that you removed at the beginning of this step. Secure the rear grill (E) to the motor housing (F) using the rear grill lock (P). Tighten the rear grill lock (P) until the rear grill (E) is secured to the motor housing (F). Secure the fan blade (C) to the motor shaft by tightening the locking screw (D) into the notch (Q) on the motor shaft. Refer to figure 7 for correct alignment of the fan blade (C) and locking screw (D) to the shaft. Please note that you may need to unscrew the grill ring screw (O) with a cross head screw driver in order to place the front grill (A) into the grill ring (B). NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. The wires in the mains lead are coloured as such: GREEN AND YELLOW - EARTH BROWN - LIVE BLUE - NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. Please proceed as follows: The wire which is coloured GREEN AND YELLOW must be connected to the terminal which is marked with the letter 'E' or by the earth symbol or coloured GREEN AND YELLOW. The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK. ASSEMBLY INSTRUCTIONS Please see pictures on inside cover pages (Fig. [. . . ] Holmes undertakes within the guarantee period to repair or replace the appliance, or any part of appliance found to be not working properly free of charge provided that · you promptly notify the place of purchase or Holmes of the problem; and · The appliance has not been altered in any way or subjected to damage, misuse, abuse, repair or alteration by a person other than a person authorised by Holmes. ⷠFaults that occur through, improper use, damage, abuse, use with incorrect voltage, acts of nature, events beyond the control of Holmes, repair or alteration by a person other than a person authorised by Holmes or failure to follow instructions for use are not covered by this guarantee. Additionally, normal wear and tear, including, but not limited to, minor discoloration and scratches are not covered by this guarantee. [. . . ]