User manual BIONAIRE BASF40G

[. . . ] PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS When using electrical appliances, basic safety precautions should always be taken including the following: · Use the fan only for purposes described in the instruction manual. ⷠTo protect against electrical shock, do not immerse the fan, plug or mains cable in water or spray with liquids. ⷠClose supervision is necessary when any appliance is used by or near children. [. . . ] ⷠIf the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid hazard. ⷠThe appliance contains no user serviceable parts and should the product suffer damage or breakdown it must be returned to the manufacturer or its service agent. NOTE: Use caution when adjusting the tilt angle of the fan head to ensure that your fingers do not get caught. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Position the Lower Pole (A) and Rubber Ring (F) over the opening of the base and secure with the Base Nut (C). ADJUSTMENT INSTRUCTIONS Tilt Adjustment Loosen Tilt-Adjustment Knob (N), move fan head to desired angle, and tighten Tilt Adjustment Knob (N) to lock in place. ⷠDo not allow water to drip on or into the fan motor housing. AND IRELAND ONLY If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. Snap Front Grill (O) into Grill Ring (P) with Bionaire logo in horizontal position, and secure with Screw (Q). (Figure 9) NOTE: You may have to loosen the Grill Ring Screw (Q) to snap the Front Grill (O) into place. NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician The wires in the mains lead are coloured as such: GREEN AND YELLOW - EARTH BROWN - LIVE BLUE - NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. Please proceed as follows: The wire which is coloured GREEN AND YELLOW must be connected to the terminal which is marked with the letter 'E' or by the earth symbol or coloured GREEN AND YELLOW. The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. [. . . ] ⷠThe rights under this guarantee shall only apply to the original purchaser and shall not extend to commercial or communal use. Waste electrical products should not be disposed of with Household waste. Check on the following website for further recycling and WEEE information: www. [. . . ]