User manual BIONAIRE BASF40

[. . . ] PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS When using electrical appliances, basic safety precautions should always be taken including the following: · Use the fan only for purposes described in the instruction manual. ⷠTo protect against electrical shock, do not immerse the fan, plug or mains cable in water or spray with liquids. ⷠClose supervision is necessary when any appliance is used by or near children. [. . . ] ⷠShould the appliance stop working, first check the fuse in the plug (UK only) or fuse/circuit breaker at the distribution board is operating, before contacting the manufacturer or service agent. ⷠIf the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid hazard. The appliance contains no user serviceable parts and should the product suffer damage or breakdown it must be returned to the manufacturer or its service agent. NOTE: Use caution when adjusting the tilt angle of the fan head to ensure that your fingers do not get caught. Before proceeding with Figure 11, remove the protective sleeve from the motor shaft. Make sure that the rear grill sits in the rear indentation and the Clip (W) is positioned at the bottom of the grill. Slide the bottom of the Front Grill (S) into the front indentation of the Grill Ring. Verify that the grills fit evenly into the indentations in the Grill Ring and tighten Screw (U). OPERATING INSTRUCTIONS (See Fig 1A & 1) Speed Control (X) = 0 - Off I - Low II - Med III - High ADJUSTMENT INSTRUCTIONS Tilt Adjustment Loosen Tilt-Adjustment Knob (E), move fan head to desired angle, and tighten Tilt Adjustment Knob (E) to lock in place. ⷠDo not allow water to drip on or into the fan motor housing. AND IRELAND ONLY If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. The wires in the mains lead are coloured as such: GREEN AND YELLOW - EARTH BROWN - LIVE BLUE - NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. Please proceed as follows: The wire which is coloured GREEN AND YELLOW must be connected to the terminal which is marked with the letter 'E' or by the earth symbol or coloured GREEN AND YELLOW. The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. [. . . ] Check on the following website for further recycling and WEEE information: www. NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. In the unlikely event of breakdown, please take it back to the place of purchase, with your till receipt and a copy of this guarantee. [. . . ]