User manual BIONAIRE BASF1714

[. . . ] · Close supervision is necessary when any appliance is used by or near children. · Unplug from the electrical outlet when not in use, when moving the fan from one location to another, before putting on or taking off parts and before cleaning. · Do not operate in the presence of explosive and/or flammable fumes. · Do not place the fan or any parts near an open flame, cooking or other heating appliance. [. . . ] Slide the fan blade (B) with the hollowed interior of the blade facing toward the rear grill, firmly onto the motor shaft. The top of the motor shaft should lie even with the centre of the fan blade. Now use the securing screw (C) (already attached to the Fan Blade) to lock the blade into place. Tighten the screw into the side hole of the fan blade, against the motor shaft, until both the blade and screw are secure. Centre the front grill (A) by aligning the Bionaire® logo on the logo plate so that it is horizontal and parallel with the floor. Then, holding the front grill against the rear grill, push the black grill ring (E) into place at the top and bottom of the fan. (Push directly on the black grill ring, not on the grills themselves). Finish securing the grill ring in the same manner until both grills are joined underneath the black ring. Insert the pole locking knob (L) into the hole on the outer pole, to securely hold this position. Place the fan head assembly into this extension pole, inserting the neck of the fan into the pole opening. Turn the fan head's neck until the head is securely locked into place. Add the tilt adjustment knob (J) to the hole in the fan head's neck. Converting to a table fan Model BASF1314 only: On model BASF1314 an additional short pole (R) is supplied which allows the fan to be converted into a table fan. To change to this short pole, remove the fan head assembly from its position on top of the inner pole and unscrew the L-shaped locking lever at the base. Remove the long pole, replace with the short pole and reassemble as detailed above. Selector (Speed) Control is located on the top of the fan motor housing. The SPEED is adjusted by turning the Selector (Speed) Control to the desired setting:O-III-II-I. The OSCILLATION control is located on the top of the fan motor housing. [. . . ] Do not allow the motor or other electrical components to be exposed to water. FAN STORAGE Your fan can be stored either partially disassembled or assembled. · If stored disassembled, we recommend using the original (or appropriately sized) box. · If stored assembled or partially assembled, remember to protect the fan head from dust. [. . . ]