User manual BIONAIRE BASF1415

[. . . ] E-mail us at enquiriesEurope@jardencs. com for further recycling and WEEE information. Holmes Products (Europe) Limited 1 Francis Grove London SW19 4DT UK pure indoor living Holmes Products (Europe) Ltd. 1 Francis Grove London SW19 4DT England Fax: +44 (0)20 8947 8272 Email: enquiriesEurope@jardencs. com Website address: www. bionaire. com UK - Free phone Customer Service Helpline ­ 0800 052 3615 STAND FAN By Steven Bauer at 8:18 am, Jun 09, 2009 MODEL: BASF1415 © 2009 Sunbeam Products, Inc. Distributed by Holmes Products (Europe) Ltd. , 1 Francis Grove, London SW19 4DT, United Kingdom. [. . . ] Turn the base cover upside down and place the weight into the base cover. Insert the threaded end of the L-shaped locking lever into the hole of the washer, weight and through the base cover. Whilst holding the base cover and weight with one hand, connect the pole to the base, sliding the L-shaped locking lever into the bottom of the pole (M) with your other hand. Turn the L-shaped locking lever clockwise to securely attach the pole to the base. Unscrew rear grill mounting nut (D) before positioning the rear grill (F) over the motor shaft (G) making certain that the notches at the top and bottom of the rear grill, fit over the prongs on the motor housing (H). Secure the rear grill in its place using the rear grill mounting nut (D). Slide the fan blade (B) with the hollowed interior of the blade facing toward the rear grill, firmly onto the motor shaft. The top of the motor shaft should lie even with the centre of the fan blade. Now use the securing screw (C) (already attached to the Fan Blade) to lock the blade into place. Tighten the screw into the side hole of the fan blade, against the motor shaft, until both the blade and screw are secure. Centre the front grill (A) by aligning the Bionaire logo on the logo plate so that it is horizontal and parallel with the floor. Then, holding the front grill against the rear grill, push the black grill ring (E) into place at the top and bottom of the fan. (Push directly on the black grill ring, not on the grills themselves). Finish securing the grill ring in the same manner until both grills are joined underneath the black ring. Insert the pole locking knob (L) into the hole on the outer pole, to securely hold this position. Place the fan head assembly into this extension pole, inserting the neck of the fan into the pole opening. Turn the fan head's neck until the head is securely locked into place. Add the tilt adjustment knob (J) to the hole in the fan head's neck (I). Converting to a table fan On model BASF1415 an additional short pole (Q) is supplied which allows the fan to be converted into a table fan. To change to this short pole, remove the fan head assembly from its position on top of the inner pole and unscrew the L-shaped locking lever at the base. Remove the long pole, replace with the short pole and reassemble as detailed above. OPERATING INSTRUCTIONS 1. Selector (Speed) Control (S) is located on the top of the fan motor housing. [. . . ] · If stored assembled or partially assembled, remember to protect the fan head from dust. AND IRELAND ONLY: If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. and Ireland N O R P NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. If a 13A 3-pin plug is fitted, it must be an ASTA approved plug, conforming to BS1363 standard. [. . . ]