User manual BIONAIRE BASF1016

[. . . ] · Any repaired or replaced appliance will be guaranteed on these terms for the remaining portion of the guarantee. The Bionaire® Group reserves the right to change or modify any specifications without notice. Waste electrical products should not be disposed of with Household waste. Check on the following website for further recycling and WEEE information: www. bionaire. com or e-mail: info-europe@theholmesgroup. com 2 CoolTM Stand Fan BASF1016 Holmes Products (Europe) Ltd 1 Francis Grove London SW19 4DT England Fax: +44 (0)20 8947 8272 Email: info-europe@theholmesgroup. com Website address: www. bionaire. com UK - Free phone Customer Service Helpline ­ 0800 052 3615 NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. [. . . ] · If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid hazard. 1 inside back page) Base assembly You will need the base cover (S, T), weighted insert (U), 1 pole (R) (either can be used as they are interchangeable) and base nut (V). A B C D E F G I J K L M N 60º IMPORTANT: Unscrew the nut underneath the weight and discard the removable plastic plug from the centre of the base. Insert one pole through the base cover and twist pole clockwise to lock in position. Be careful to align the cutaway grooves on the threaded joint (male end) with the two protruding raised pieces inside the hollow end of the base cover. Now turn the base cover upside down (pole facing floor) and place the weighted insert into the base cover. The pole threads will be exposed as they protrude through the base insert. Hold the pole, base cover and weighted insert in one hand, place the base nut on the threaded section and hand tighten the base nut with the other hand. Pole assembly You will need the second pole (O) (The poles are interchangeable). Insert the pole with the threaded joint (male end), into the hollow end of the second pole until both poles meet. Be careful to align the cutaway/grooves on the threaded joint (male end) with the two protruding pieces inside the hollow end of the second pole (female end) (P). Now slowly turn the pole with the threaded joint clockwise to lock it securely in place. Position the rear grill (G) over the motor shaft (I) making certain that the 2 notches at the top and bottom of the rear grill, fit over the 2 prongs on the motor housing (J, M). Please make sure the rear grill sits securely against the motor housing. Secure the rear grill in its place using the rear grill mounting nut (F). Position the large fan blade (E), with the hollowed interior of the blade facing towards the rear grill, firmly onto the motor shaft. Align the motor shaft pin with the recessed groove on the back of the fan blade. Position the small fan blade (D) into the hollowed interior of the large blade and press firmly into place. Secure the fan blades onto the motor shaft by turning the blade cap (C) anti-clockwise and tighten firmly. Centre the front grill (B) by aligning the Bionaire® logo on the logo plate (A) so that it is horizontal and parallel with the floor. Then, secure the front and rear grills completely together by pushing the front grill onto the clips, whilst holding the clips in place. Final assembly 1. Insert the fan neck joint into the hollow end of the top pole and slowly turn the neck joint to lock in place. [. . . ] Please remember: · Always unplug the fan before cleaning or assembly. · Be sure to use a soft cloth, moistened with a mild soap solution. · Do not use any of the following as a cleaner: petrol, thinners or benzine. Replace the fan blade, tighten screw and securely fasten the front grill. [. . . ]