User manual BIONAIRE BASF 1714

[. . . ] Unplug from the electrical outlet when not in use, when moving the fan from one location to another, before putting on or taking off parts and before cleaning. Do not place the fan or any parts near an open flame, cooking or other heating appliance. Do not operate any appliance with a damaged cord, plug, after the appliance malfunctions, or has been dropped/damaged in any manner. The use of attachments not recommended or sold by the appliance manufacturer may cause hazards. [. . . ] Centre the front grill (A) by aligning the Bionaire® logo on the logo plate so that it is horizontal and parallel with the floor. Then, holding the front grill against the rear grill, push the black grill ring (E) into place at the top and bottom of the fan. (Push directly on the black grill ring , not on the grills themselves). Finish securing the grill ring in the same manner until both grills are joined underneath the black ring. Insert the pole locking knob (L) into the hole on the outer pole, to securely hold this position. Place the fan head assembly into this extension pole, inserting the neck of the fan into the pole opening. Turn the fan head's neck until the head is securely locked into place. Converting to a table fan Model BASF1314 only: On model BASF1314 an additional short pole (R) is supplied which allows the fan to be converted into a table fan. To change to this short pole, remove the fan head assembly from its position on top of the inner pole and unscrew the L-shaped locking lever at the base. Remove the long pole, replace with the short pole and reassemble as detailed above. ADJUSTMENT Tilt adjustment Follow these instructions to tilt the fan head for upward angle air movement. To change the tilting angle of the fan head, simply loosen the tilt adjustment knob (J) 2. Move the fan head to the desired angle, then firmly tighten the knob to lock in place. CLEANING AND MAINTENANCE Follow these instructions to correctly and safely care for your Bionaire® fan. please remember:· Always unplug the fan before cleaning or assembly. Do not use any of the following as a cleaner: petrol, thinners or benzene. Replace the fan blade, tighten screw and securely fasten the front grill. Fan head, base and pole cleaning Using a soft, moist cloth, with or without a mild soap solution, carefully clean the fan base, pole and head. Do not allow the motor or other electrical components to be exposed to water. FAN STORAGE Your fan can be stored either partially disassembled or assembled. [. . . ] No rights are given under this guarantee to a person acquiring the appliance second hand or for commercial or communal uses. Waste electrical products should not be disposed of with Household waste. Check on the following website for further recycling and WEEE information: www. Het tafelmodel ­ Alleen model 1314: Bij model 1314 zit een extra korte standaard (R) waarmee u de fan tot tafelmodel kunt verbouwen. [. . . ]