User manual BIONAIRE BAP422RC-CN

[. . . ] Never block the air openings, or place on soft surface, such as bed or sofa, as this could cause the unit to tip over thus blocking the air intake opening. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. WARNING: To reduce the risk of fire or electrical shock, DO NOT use this air purifier with any solidstate speed control device. To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. [. . . ] The clip can only be attached to the tabs on the filter in only one way. The filter clip should easily slide onto the filter hang tab with only a small amount of pressure. Align the clip on the top of the HEPA-Type filter with the rails on the inside of the purifier unit. The unit will turn onto high and the power light will illuminate letting you know the power is on. You can select from HIGH ( ), MEDIUM ( ), or LOW ( ) by pushing the desired operating speed button on the control panel or the remote control. To release negative ions into the filtered air, turn the ionizer knob to ON ( ) and the light will illuminate. For continuous use, it's recommended to operate the air cleaner at the MEDIUM ( ) setting. For quieter operation or use in a bedroom, select the LOW ( ) setting. When high levels of air pollution are present, select the HIGH ( ) setting to quickly circulate and filter the room air. To install the batteries, simply depress and slide the back of the remote control with your thumb on the arrow indentation. Insert batteries according to the diagram shown inside and replace cover. To turn the air cleaner on, press the power button ( ) and then select the desired operating speed by pressing any speed button on the remote control or on the control panel. The speed is adjustable by pressing either the Speed Buttons: HIGH ( ), MEDIUM ( ), or LOW ( ) on the remote control or on the control panel. To turn the unit off, press the power button ( ) on either the remote control or on the control panel. To turn the Ionizer on, press the ionizer button ( ) on either the remote control or the control panel. The outside of the air purifier can be cleaned with a soft, damp cloth. WARNING: Do not allow moisture to come in contact with the main housing of the air purifier. If it has collected a noticeable amount of dust or lint, remove it from the inlet of the grill and wash it in warm soapy water. Rinse and drip dry the pre-filter thoroughly before replacing it into the inlet of the grill. Your air purifier is equipped with a filter indicator light which will alert you when it is time to change the filter. When the filter indicator light goes on, check the condition of the HEPA-Type filter. If the filter is dirty, remove the used HEPA-Type cartridge and properly dispose of it. [. . . ] JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory warranty or condition. Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. jCS disclaims all other warranties , conditions or representations , express , implied , statutory or otherwise. JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. [. . . ]