User manual BIONAIRE BAP1452-CN

[. . . ] NEVER block the air openings, grills/outlets or place on a soft surface such as a bed or sofa, as this could cause the unit to tip over, blocking the air intake opening/grill. â· DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. The inside of the unit contains no user WARNING: To reduce the risk of fire or electric shock, DO NOT use this air cleaner with any solid-state speed control device. CONSUMER SAFETY INFORMATION TO REDUCE THE RISK OF ELECTRIC SHOCK, THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC (Alternating Current) PLUG (a plug having one blade wider than the other. [. . . ] Select a firm level place where there are no obstructions to the air inlet or filtered air outlet. A good location in a room is approximately 1 foot away from the wall, in a central location of your home. Pull rear air inlet grill towards you by grasping the finger tabs and pulling forward. The filter clip should easily slide onto the filter hang tab with only a small amount of pressure. Align the clip on the top of the PERMAtechTM filter with the rails on the inside of the air cleaner unit. To release negative ions into the filtered air, turn the ionizer knob to ON ( ) and the Ionizer light will illuminate. The outside of the air cleaner can be cleaned with a soft, clean dampened cloth. The filtered air outlet can be cleaned of dust with a small, soft brush. Instruction Leaflet INFO-LINE If after having read this leaflet, you have any If you wish to clean the inside of the air cleaner, please only use a dry, soft cloth to wipe it down. Filter Indicator - a filter reminder dial is manually set to remind the user when it is time to replace the filter. If the foam pre-filter has collected a noticeable amount of dust, remove it from the inlet of the grill and wash it in warm soapy water. Rinse and dry the pre-filter thoroughly before replacing it in the inlet of the grill. With the inlet grill removed, check the condition of your PERMAtechTM filter. If the filter is dirty, remove them by gripping on both sides and pulling forward. To clean the PERMAtechTM filter use a brush attachment with your vacuum cleaner. Run the attachment along the inlet and outlet side of the filter trying to clean between the pleated filter layers (See Fig. NOTE: Vacuuming will restore performance of the PERMAtechTM filter however, the filter may appear stained. Before replacing the PERMAtechTM filter make sure that the hang tab is securely in place. Align the clips on the side of your PERMAtechTM filter with the rails on the inside of the unit. Align the clip on the side of your PERMAtechTM filter with the rails on the inside of the unit. 3 and 4) NOTE: The pleated material and rubber gasket should be facing towards the unit when applied. Filter Life - The filter has been designed to never need replacement, however, it does need servicing. [. . . ] This warranty gives you specific legal rights, and you may also have other rights that vary from province to province, state to state or jurisdiction to jurisdiction. If you have any question regarding this warranty or would like to obtain warranty service, please call 1-800-253-2764 and a convenient service center address will be provided to you. In Canada If you have any question regarding this warranty or would like to obtain warranty service, please call 1-800-253-2764 and a convenient service center address will be provided to you. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, located at 20B Hereford Street, Brampton, Ontario L6Y 0M1. [. . . ]