User manual BIONAIRE BAP1225-CN

[. . . ] When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: · Read all instructions before using appliance. If the filter is covered by a bag when shipped: remove plastic bag before use. To avoid fire hazard NEVER put cords under rugs, near heat registers, radiators, stoves or heaters. ⷠTo protect against electrical hazards DO NOT immerse in water or other liquids. [. . . ] The carbon filters, which are packed in a plastic bag in the box, should be removed from plastic bag and then placed on each of the HEPA filters. The filter Figure 1 should easily slide onto the filter hang tab with only a small amount of pressure. Replace the front grill by swinging door Figure 2 closed and gently press until front grill is firmly in place. Carefully remove your EnviroCheckTM Wireless Air Quality Center from the packaging materials. Select a firm level place on a tabletop or counter where there are no obstructions to the venting holes. This includes things like smoke, dust, pollen, ragweed, grasses, mold spores, dust mite debris and pet dander. carbon Filter Indicator ­ When the carbon filter indicator light turns red it is time to change the carbon filters. HEPA Filter Indicator ­ The filter life monitor uses a series of lights to give you an indication of the remaining filter life. As the filter life progresses the filter life indicator will move to yellow and your HEPA filters should be checked for particulate accumulation. When the filter life indicator light is red, it is time to change the HEPA filters. enviroCheckTM Wireless Air Quality Center ­ Multifunctional providing an indoor air quality display , auto mode , programmable controls , remote operation of air cleaner as well as a clock and alarm mode. Air Quality Sensor ­ Uses an advanced infrared optical system to constantly detect tiny airborne particles in the air around the EnviroCheckTM Wireless Air Quality Center, such as pollen and dust. It displays the air quality conditions using a series of LED lights glowing red when high levels of particles are present and green when air quality is improved. The hour L numbers will begin to flash and a small bell will appear in the bottom right hand corner of the LCD screen. When a button has not been pressed for a few seconds OR when the "SET" button is pressed again, the minute numbers will begin to flash. Press the "+" and "-" buttons to adjust the minutes as indicated above in step 2. When a button has not been pressed for a few seconds OR when the "SET" button is pushed again the time will appear on the LCD screen and the alarm is set. A small bell will now appear in the bottom right hand corner indicating the alarm is operational. Press the "ALARM" button when the alarm is sounding and the alarm will turn off. The alarm will continue to go off every 10 minutes until the alarm mode is deactivated. Instruction Leaflet INFO-LINE If after having read this leaflet, you have any Questions or comments on your air cleaner, call 1-800-253-2764 in North America. The air cleaner will begin to beep continuously until it is synchronized with the EnviroCheckTM Wireless Air Quality Center. [. . . ] The lights range in color from green which indicates good air quality conditions or low levels of airborne particulate to red which shows poor air quality conditions or high levels of airborne particulate. ⷠThe air quality sensor operates continuously when the EnviroCheckTM Wireless Air Quality Center is plugged into a 120V AC outlet, even when the air cleaner is turned off. The pre-filter must be washed at least every 30 days or more often as necessary. After washing, rinse and dry the pre-filter thoroughly before replacing it into the air cleaner door. [. . . ]