User manual BIONAIRE BAOF25W

[. . . ] PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS When using electrical appliances, basic safety precautions should always be taken including the following: · Use the fan only for purposes described in the instruction manual. To protect against electrical shock, do not immerse the fan, plug or mains cable in water or spray with liquids. Close supervision is necessary when any appliance is used by or near children. [. . . ] NOTE: Use caution when adjusting the tilt angle of the fan head to ensure that your fingers do not get caught. align the 4 screw holes in the base to the four holes in the upper body. Fix securely with the 4 sets of screw, spring washer and flat washer (C). Position the rear grill (F) over the motor shaft (G), making certain 2 notches (H) at the sides of the rear grill fit over the corresponding prongs (I) on the motor housing. Please make sure the rear grill fits securely against the motor housing. Slide the fan blade (J), with the fixing screw facing towards the rear grill, firmly onto the motor shaft, aligning the screw with the flat (K) on the motor shaft. Tighten the screw into the side hole of the fan blade, against the motor 7. Position the fixing screw (O) at the bottom of the grill with reference to the Bionaire® logo. Locate the front grill to one of these grooves leaving the other groove free to attach to the rear grill. Centre the front grill by aligning the Bionaire® logo on the logo plate so that it is horizontal and parallel with the floor. Then, holding the front grill against the rear grill, push the black grill ring into place at the top and bottom of the fan. Finish securing the grill ring in the same manner until both grills are joined underneath the black ring. The SPEED is adjusted by turning the Speed Control to the desired setting: 0 - Off I - Low II - Med III - High ADJUSTMENT Tilt adjustment To change the tilting angle of the fan head, simply move the fan head to the desired angle. AND IRELAND ONLY If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. The wires in the mains lead are coloured as such: GREEN AND YELLOW - EARTH BROWN - LIVE BLUE - NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. The wire which is coloured GREEN AND YELLOW must be connected to the terminal which is marked with the letter 'E' or by the earth symbol or coloured GREEN or GREEN AND YELLOW. [. . . ] Waste electrical products should not be disposed of with Household waste. Check on the following website for further recycling and WEEE information: www. HASTIGHETEN justeras genom att vrida hastighetsväljaren till önskad inställning: O - Av I - Låg II - Med III - Hög JUSTERING Justering av lutning Justera fläkthuvudet genom att helt enkelt flytta det till önskad lutning. [. . . ]