User manual BEITER NP

[. . . ] Update 01/2004 Serving a Nocking Point The Beiter Nocking Point is made out of two identical halves, which must be served into the serving, paying attention to fit pins and holes. [. . . ] Tools that you need: 1 Beiter WINDER (or other string server) with the desired serving material, 1 Beiter Nocking Point (2 halves), 1 Gauge, 1 pencil, 1 Fastener with elastic band. Following short guide shows how to serve a Beiter Nocking Point: Set your nocking point with the checker and mark the correct position with a pencil. It is better to mark not only the position of the higher inner shoulder, but also the lower inner shoulder and the end of the Beiter Nocking Point itself: in this way you can better control the position of the Nocking Point during the serving procedure. Every single archer has its own way to serve a serving and especially how to begin to serve it. We use a Fastener with elastic band to hold the thread, allowing both hand to be free. Pull the Fastener to the string: so you have easily set the start for your serving. Turn the yarn respectively the Fastener 4-5 times around the string, to be able to enter to the in-going thread indentation of the nocking point with a very flat angle. Fix the two halves of the Nocking Point on the string (paying attention to match holes and pins). On each half of the Nocking Point there is a left and a right turning indentation: in this way you will always find one in the correct turning direction. Wrap the yarn around the nocking point, tightly but with not excessive tension. Tel. +49 7720 856860 Fax +49 7720 4238 email: info@wernerbeiter. com Werner Beiter Daimlerstr. [. . . ] +49 7720 856860 Fax +49 7720 4238 email: info@wernerbeiter. com www. WernerBeiter. com [. . . ]