User manual BEITER CS

[. . . ] - CLEARANCE STAR CONTENT: 11 Clearance Stars, 1 Clearance Star Tool, 1 Clearance Star Box and Instructions. [. . . ] The Beiter Clearance Star has 11 rays, therefore the rays at 11 and 1 o'clock should be positioned on the edges of the V-cut of the Tool. Slip over the shaft and position the Beiter Clearance Star with the aid of the Tool. Apply as many Clearance Stars as needed in a row at the distance and spacing you wish, to reveal the contact points of the the arrow shaft with the arrow rest, the plunger tip, the bow window or the bow hand. It is important to align the Beiter Clearance Star with the nock (V-cut at 12 o'clock), so you can determine the exact contact points, if your clearance is not good. Examine the Beiter Clearance Star to see if any of the"rays" on the arrow have been bent!3a straight and 3b bent) According to the position you will know where you have a problem with your tuning/clearance. Re-do the test after having set the bow differently (changing the nocking point height, the arrow position on the rest, the rest position, the plunger tension, the tiller, . . ) and continue either until there is no contact or your reach the desired contact marks!Beiter Clearance Stars can be re-used if the "rays" are only bent; the "rays" may break in the event of strong impact, in which case the Clearance Star must be replaced. [. . . ] +49/7720/856860 Fax+49/7720/4238 www. wernerbeiter. com MADE IN GERMANY e-mail: info@wernerbeiter. com [. . . ]