User manual BARNETT CROSSBOWS QUAD 400 CRANK COCKING DEVICE

[. . . ] QUAD 400 CRANK COCKING DEVICE ASSEMBLY, INSTALLATION & OPERATION GUIDE SAFETY GUIDELINES DO NOT TURN HANDLE BACKWARDS WHILE DRAWING THE BOW!!The Latch mechanism should always be engaged when cocking the crossbow. An audible clicking sound should be present while turning the handle in a forward rotation. [. . . ] Product returned without a return authorization number will be refused. Write return authorization number on outside of package and attach to the product your name, address, telephone number and letter describing the problem. Carefully package and return, transportation prepaid to: Barnett International, Inc. Attn: Service Department 13447 Byrd Drive Odessa, FL 33556 THIS PAGE INTENTIONALLY LEFT BLANK CRANK ASSEMBLY STEP 1 NOTE: ANCHORS WILL GO OVER STRING FROM SPOOLS TO CONTAIN THEM IN THE GROOVE 2. LEFT SIDE STRING SPOOL Insert 1/8" pins (5) into right side string spool, then insert right side string spool into middle stock hole. (Note: You may apply a white lithium grease to the spool bushing to reduce friction. ) Insert left side string spool (1) into middle stock hole. It is important to keep the string spools position the same way on either side to allow even take up of string during use (see note below). 5/8" (4) socket head cap screw into right side string spool (2) and thread into left side string spool (1). To tighten, align crank handle (6) with left side string spool (1) and thread in thumb screw (3). Using supplied allen wrench tighten 1/4-20 x 5/8" socket head cap screw (4). NOTE: BE SURE THE STRING IS AT EQUAL LENGTHS AND THE KNOT HOLE ON BOTH RIGHT AND LEFT STRING SPOOLS ARE IN LINE WITH EACH OTHER WHEN CONNECTING THEM TOGETHER (#'s 1 & 2). CRANK ASSEMBLY STEP 2 STRING 7. #10 -24X1" SOCKET HEAD CAP SCREW Insert right side string anchor (7) into front stock hole. Insert #10-24X1" socket head cap screw (11) into left string anchor and tighten. Press Finish Caps (9 & 10) into right and left anchor holes. CRANK ASSEMBLY STEP 3 CONNECT STRING PULLER ASSEMBLY USING DOVETAIL UNDER FRONT OF SCOPE MOUNT WHEN NOT IN USE. 15. Insert #440 socket head cap screws (14) through catch plate and thread into spool catch. Press catch cover (15) into hole when completed. WARNING: NEVER USE YOUR CRANK DEVICE TO UN-COCK/ UN-LOAD STRING FROM TRIGGER CRANK OPERATION NOTE: TO DISENGAGE THE RATCHET FEATURE PLACE TOGGLE SWITCH INTO THE BACK AND DOWN POSITION. NOTE: WHEN CRANKING THE STRING BACK, PLACE THE TOGGLE SWITCH IN THE FORWARD POSITION TO ACTIVATE THE RATCHETING FEATURE. [. . . ] Place String Puller Assembly on bottom dovetail of scope mount to keep out of the way when shooting. BARNETT INTERNATIONAL INC. USA 13447 BYRD DRIVE ODESSA, FL 33556 PHONE: 800-237-4507 FAX: 813-920-5400 BARNETT INTERNATIONAL, INC. UK DIVISION DOCK MEADOW DRIVE, LANESFIELD WOLVERHAMPTON, WEST MIDLANDS ENGLAND WV46UD PHONE: 01902405121 FAX: 01902409447 Warranty registration card (below) must be mailed within 10 days of purchase to validate the warranty. WARRANTY CARD Name_______________________________________Age_____________ Address_____________________________________________________ City _________________________State__________Zip______________ Date of Purchase ___________________Phone # ___________________ Place of Purchase __________________________Price Paid__________ Purchase Address_____________________________________________ City__________________________State__________Zip_____________ Registration completed by: Dealer ( ) Consumer ( ) [. . . ]